14.2 Setting up Home Con-
nect
Requirements
¡ The Home Connect app has been
installed on your mobile device.
¡ Wi-Fi has been activated on the
router.
¡ The appliance is receiving signals
from the WLAN home network (Wi-
Fi) at its installation location.
Use the Home Connect app to
1.
scan the QR code.
Follow the instructions in the
2.
Home Connect app.
14.3 Activating Wi-Fi on the
appliance
Note: When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
Press and hold
1.
for approx. 3 seconds.
Set the programme to position 4.
2.
a The display shows Con .
Press Start/
3.
until the display shows on .
a Wi-Fi is activated.
Note: If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
Remote Start
Pause repeatedly
14.4 Deactivating Wi-Fi on the
appliance
Press and hold
1.
for at least three seconds.
Set the programme to position 4.
2.
a The display shows Con .
Press Start/
3.
until the display shows oFF .
a Wi-Fi is deactivated.
Note: The connection is automatically
re-established when the Wi-Fi is
switched back on.
14.5 Resetting the appliance
network settings
Press and hold
1.
for at least 3 seconds.
Set the programme to position 5.
2.
a The display shows rES .
Press Start/
3.
a The display shows "YES" .
Press Start/
4.
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
14.6 Remote start
Enable the appliance for remote start
via the Home Connect app.
Activating remote start
Note
Remote start is deactivated for safety
reasons in the following
circumstances:
¡ Open the appliance door.
¡ Press Start/
¡ Press
Remote Start .
¡ Switch off the appliance.
¡ Following a power cut.
Home Connect en
Remote Start
Pause repeatedly
Remote Start
Pause .
Pause .
Pause .
33