Advertisement
ASSEMBLY INSTRUCTIONS
2. Mount with mounting holes
Hold housing in place so that the housing contacts the bottom of the joist,
Screw housing to joist through the hole A and hole B.
3. Mount with Hanger Bars
Slide one hanger bar into the channel on the housing and adjust as
needed to fit between framing. Hold housing in place so that the housing
contacts the bottom of the joist, Screw housing to joist through the hole A
and hole B. Screw the hanger bar onto the other side of joist through its
hole.
Screw hanger bar to housing with screw A.
4. Mount to I-joist
Slide hanger bar into the channel on the housing and adjust as needed
to fit I-joist. Hold housing in place so that the housing contacts the bottom
of joist. Screw housing to joist through the hole A and hole B. Screw the
hanger bar onto the joist through its hole.
Screw hanger bar to housing with screw A.
5. Wall installation
5a. When the product is installed on the wall, the adaptor shall be faced upward.
5b. Slide hanger bar into the channel on the housing. Hold housing in place so that
the housing contacts the bottom of stud. Screw housing to stud through the hole
A and hole B on the same side. Screw the hanger bar onto the stud through its
hole.
Screw hanger bar to housing with screw A.
The minimum installation distance between studs is 13 3/8 in. (340mm)
Screw B
3
Screw B
Screw A
Screw B
Screw B
Screw A
Screw B
Hanger
bar
Screw A
Screw B
Stud
Screw B
Advertisement
