Advertisement
Cord Connection
NOTE: Do not plug your extension cord into the power source
receptacle (outlet) prior to routing it through the cord retainer
and connecting the extension cord to the mower's cord outlet
receptacle.
To properly route your extension cord through the cord retainer:
1.
Approximately 14 to 16-inches from its end, crease your
extension cord to form a tight loop.
2.
Push the loop through the bottom hole in the cord
retainer. See Fig. 3-7.
3.
Position the loop over the clip found on the cord retainer
and pull down until the cord fits snugly into the clip. See
Fig. 3-7.
NOTE: Use a UL-approved extension cord. A 100-foot,
14-gauge cord is recommended. A 50-foot, 16-gauge
cord is acceptable. Refer to the small chart found in Safe
Operation Practices.
NOTE: The cord retainer secures your extension cord and
safely limits its movement.
10
s
3 — a
ectiOn
sseMbly
1
Figure 3-7
& s
-u
et
p
Grass Collection
1.
To assemble the grass bag, secure the plastic channels of
grass bag over frame rods. See Fig. 3-8.
Frame Rod
2.
Follow steps below to attach grass catcher:
a.
Lift rear discharge door.
b.
Remove rear mulching baffle. See Fig. 3-9.
NOTE: Swing the mulching baffle to the right side of the
mower and then slide out.
2
Plastic Channels
Figure 3-8
Figure 3-9
Advertisement
