Square Jellyfish MICRO BALL HEAD User Manual

SqUare JellYfiSH Micro Ball Head USer'S ManUal
Thank you for purchasing the Square Jellyfish Micro Ball Head. This product is
designed for use with pocket cameras to add camera angle flexibility to a tripod.
You will need two things:
• A camera weighing up to 9 oz. with a tripod screw mount.
• A tripod with a 1/4 x 20 standard camera thread screw. Alternatively, the
Square Jellyfish Pocket Tripod may be also be used.
Set up in two
simple steps:
• Gently
thumb-tighten
the screw of the
Micro Ball Head
onto the screw
mount of your
pocket camera.
• Gently
thumb-tighten
the base of the
Micro Ball
Head onto
thread screw
of your tripod.

Use common sense

• Do not place your camera where it can easily fall a distance that would cause
damage to your camera.
• This product contains small parts that may be a chocking hazard. Keep out
of reach of children.

Position your camera

Once set-up is complete, you
can then position your camera
in a broad range or angles. The
built-in tension of the Ball Head
holds your camera firmly in place.
If desired, a small screwdriver
can be used to adjust the tension
looser or tighter by slightly turning
the recessed set-screw at the
bottom of the Micro Ball Head.
www.squarejellyfish.com
Designed in USA. Made in China. Patent pending.
Micro Ball Head shown with
conventional tripod
Micro Ball Head shown with
Square Jellyfish Pocket Tripod