Table of Contents
Advertisement
PREPARATION
Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. and
turn on the power switch in the rear of the unit. Only operate heater in upright position with
caster wheels attached.
Insert 2 AAA batteries into the remote control before using (Batteries Not Included)
OPERATING INSTRUCTIONS
1 Start and select working mode
Or
Or
2 Setting Desired Temperature
Or
3 Setting flame
Or
Turn the heater on by pressing the POWER button on the
control panel or by pressing the Power button on the
supplied remote control.
Once power is off, heating element will stop working at first.
Fan will prolong working for 3 min to emit plenty of heat
inside. This mark will indicate running during the 3 min.
Select a heat setting.
Press the HEATER button to toggle between the two heat
settings.
Power for heat-up mode is 1500W; heat-down is 750W,and
turn off the heat.
Adjust the desired temperature by pressing the Up/Down
arrows on the con trol panel or remote control.
Desired temperature options vary from 59
you have chosen the desired temperature, the heater will
remain on until the room temperature increases to the
temperature on the digital display. The heater will cycle on
and off to maintain the desired room temperature.
Adjust the brightness of the flame and turn off.
7
to 95 . Once
Advertisement
Table of Contents
