Summary of Contents for RD WORKS GD9315BCW-FPR
- Page 1 INFRARED ZONE HEATING SYSTEM OWNER’S MANUAL Model No. GD9315BCW-FPR PLEASE SAVE THESE INSTRUCTIONS WARNING: READ THIS OWNER’S MANUAL CAREFULLY BEFORE USE.
-
Page 2: Important Instructions
Thank you for choosing a RD-WORKS Infrared Zone Heating System. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new heater. -
Page 3: Specifications
17. Use only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by unauthorized dealers may cause hazards. -
Page 4: Product Diagram
WARNING: This heater has a voltage rating of 120 volts. The cord has a plug as shown in A. An adapter as shown in C is available for connecting three-blade grounding-type plugs to two-slot receptacles. The grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box. - Page 5 Control Panel 1. Timer button: User setting timing boot or shutdown . 2. Flame light button: Adjust the brightness of the flame . 3. Heater button: Set up the heater mode and turn off the heat. 4. Power indication light: After electrifying show red, press the power button to display the red light and flame open.
- Page 6 Note This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
- Page 7 PREPARATION Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. and turn on the power switch in the rear of the unit. Only operate heater in upright position with caster wheels attached. Insert 2 AAA batteries into the remote control before using (Batteries Not Included) OPERATING INSTRUCTIONS 1 Start and select working mode...
- Page 8 4 Setting the POWER OFF TIMER Function Note: The Power-Off-Timer Function will allow for the heater to power OFF after a certain set time, and can only be set while the heater’s display is in the “On” position. Turn the heater to the “On” position .Press the Timer button on the heater’s control panel or the remote.
-
Page 9: Maintenance
Press Temp Up and Temp Down buttons at the same time for 3 seconds. Locking is complete when you hear a beep. When locked, the functions of the control panel and remote will be locked for use. When you need to unlock it, press Temp Up and Temp Down buttons at the same time for 3 seconds. -
Page 10: Basic Troubleshooting
The unit 2) Remove Air filter 1) Remove bracket screws (4X) 8. If you do not use the heater for a long time, please take out the remote batteries (to prevent corrosion ) as shown below. Store the remote in a safe place. PUSH Battery STORAGE...