Table of Contents
Advertisement
4) Press
/
to select "Start," then press ENTER.
e.g.
Entire disc contents excluding
Format
5) Press
/
to select "Start," then press ENTER.
Initialization starts.
e.g.
Format
When initialization is completed, the setup window
disappears.
DVD-RAM physical format
Physical formatting is a simple execution for a disc which
cannot be used or read (or which is becoming hard to
read). It may refresh such a disc for recording and
playback. (There is no guarantee that all such discs will
be recovered.)
"DVD-RAM logical format" process only rewrites certain
data on file system and management information,
however, "DVD-RAM physical format" rewrites all data on
a disc, therefore it takes a much longer time to complete.
For a 4.7GB single sided DVD-RAM, about 70 minutes
will be necessary. While processing, all recorder
operations and functions including program recording will
not work until the process is finished. Also this process
erases all data stored on the DVD-RAM disc.
DVD format
library data will be erased
if disc is formatted. Proceed?
Start
Cancel
DVD format
DVD
Formatting
1) During stop, press SETUP.
2) Press
then press ENTER.
e.g.
0
%
3) Press
format," then press ENTER.
4) Press
to execute.
18
%
To cancel, select "No", then press the ENTER
button.
5) Read the message, and press
"Yes" or "No", then press ENTER.
Notes
• The physical format process may fail if executed to a dirty
DVD-RAM disc. Also, the disc may be difficult to record,
even if it finished. Before executing DVD-RAM physical
format process, be sure to confirm the disc is not dirty.
Clean it if necessary. If the disc has scratches or dust
beyond cleaner's efficacy, do not execute DVD-RAM
physical format process on the disc.
• The following DVD-RAM discs require physical formatting:
– A disc which is not formatted correctly.
– The disc which has errors during writing because of dirt
on the disc, and cannot be further recorded, or cannot
initialize normally.
• You need to start physical formatting from the first step
again when you use a failed disc.
• Physical formatting does not work if the disc contains a lot
of voids beyond the limitation of this recorder.
• If an error occurs in physical formatting, "ERR-01" appears
in the front panel display. To turn off the message, press
the DISPLAY button on the remote control.
/
to select "Management settings"
Management settings
Genre setting
Off
Eco. mode
Off
HDD auto stop
All HDD titles delete
HDD format
DVD-RAM physical format
Software version
DVD drive software
/
to select "DVD-RAM physical
/
to select "Yes," then press ENTER
Warning: It will take approximately
70 minutes to format a 4.7GB DVD
and all data will be erased. Confirm
that timer programing is not
scheduled. Proceed?
Yes
No
SETUP
/
to select
29
Advertisement
Table of Contents
