Table of Contents
Advertisement
RATIOMETRIC AND VOLTAGE AMPLIFIED OUTPUT
CURRENT AMPLIFIED OUTPUT - mod. E
The interface with SRP/CS (Safety Related Part of a Control System) is made by mean of multipolar connectors showed
on pictures below, where the connections are specified in case of amplified voltage output (3 wire) or current output (2 wire
system, the sensor is connected in series with the current loop).
LOAD DIAGRAM (Current output)
Ω
POWER SUPPLY VOLTAGE
RL = < (Vsupply - 10V) / 0.02A
Z - 4 pole male
connector M12 x 1*
2 1
3 4
4 pin Male connector Type
Protection IP67
* IP67 with female homologated connector mounted, tightening torque 0.6Nm + low strength threadlocker
85194E_MAN_Electrical Installation for Probes_KS and KS-SIL2 Series_08-2022_ENG
Electrical connections
CONTROLLER
SUPPLY
AMPLIFIER
OUTPUT
CONTROLLER
SUPPLY
SIGNAL
Interfaces with SRP/CS and voltage devices
Operating
Area
E - EN 175301-803
4 Pin DIN Type A
Protection IP65
cod. C
cod. Z
cod. E
cod. C
cod. Z
cod. E
F – 2/3 pole cable
Shield
Shielded cable 3x0,25 - 1 m
Protection IP65
C – EN 175301-803
4 pin MicroDIN Type C
Protection IP65
cod. F
Red
Black
White
cod. F
Red
Black
White
Red
Black
3
Advertisement
Table of Contents
