Page 1
600mm Touch Control Ceran Hob U156TCD Instruction Manual IN ORDER TO OBTAIN THE GREATEST SATISFACTION FROM YOUR APPLIANCE, IT IS RECOMMENDED YOU READ THE INSTRUCTIONS CAREFULLY...
Page 2
Introduction Dear Customer Thank you for choosing this quality, Univa Touch Control Ceran Built-in Hob. This User Manual contains important safety information and instructions on the operation and maintenance of your appliance. Please take the time to read this User Manual before using your appliance and keep this book for future reference.
Icon Type Meaning Warning Risk of Serious Injury or Death Risk of Electric Shock Dangerous Voltage Risk Fire Risk of Fire / Flammable Materials Caution Injury or Property Damage Risk Important Note Operating the System Correctly For Information For your Information SAFETY AND WARNINGS Before the installation and use of the appliance, carefully read the supplied User Manual.
Page 4
General Safety WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. • Do not operate the appliance by means of an external timer or separate remote-control system. WARNING: Do not leave hot fat or oil unattended. If overheating occurs, these could catch fire. Never try to extinguish a fire with water, but switch off the appliance and then cover flame e.g.
SPECIFICATIONS Model Volts 220V –240V 50Hz~ Amperes 28.5 A Total Power (W) 6400 W Product Dimensions Width 600mm Depth 530mm Aperture Dimensions Width 560mm Depth 490mm Cooking Zone Diameter Cooking Zone Specification Nominal Power (max Watts) (mm) Left Front (Dual Plate) 210 / 120 1450 / 750 Left Rear...
Page 6
• If the hob is installed with a side adjacent to a vertical kitchen cabinet, the distance between the edge of the hob and that of the cabinet side should be a least 150mm. The distance between the back wall and the rear edge of the hob should be at least 55mm. Aperture Size •...
• Before carrying out any operation make sure that the appliance is disconnected from the power supply. • Ensure that the parameters on the rating plate are compatible with the electrical ratings of the mains power supply. • Make sure the appliance is installed correctly. Loose and incorrect electricity mains cable can cause the terminal to become too hot.
Page 8
Hob Controls On/Off Sensor – To activate and deactivate the power. Cooking Zone Selection and (+) Sensor – To select cooking zone. Cooking Zone Power Indicator (and Hot Surface Indicator) – To show the heat setting. (-) Sensor – To adjust cooking zone power down. Dual Zone On/Off Sensor –...
WARNING! There is a risk of burns from residual heat. The “H” indicators show the level of the residual heat for the cooking zones you have been using. The indicators may also come on for the neighbouring cooking zones even if you have not used them. Dual Cooking Zone •...
• Any spillage of sugar solution such as jam, must be removed immediately. If allowed to cool on the Ceran glass it could pit and damage the surface. • The bottom of the cookware must be as thick and flat as possible. Ensure pan bases are clean and dry before placing on the hob surface.
Page 11
Univa shall not be liable for any loss or damage suffered by the customer or any other party or caused to the appliance arising from negligent use.
Page 12
➢ Howick Mews, Waterfall Park, Bekker Road, Vorna Valley, Midrand, Gauteng, South Africa ➢ P.O. Box 1482, Halfway House, Gauteng, 1685 ➢ Sales and Marketing Tel: +27 11 315 0015 Email: sales@univa.co.za ➢ Service and Spares: Tel: +27 11 315 0015 Email: support@univa.co.za...
Need help?
Do you have a question about the U156TCD and is the answer not in the manual?
Questions and answers