Carver Mini C Operation, Installation, And Maintenance Manual page 8

•
NEVER operate press without shields in place to protect the operator from the hazards of projectiles from
molds and tooling not centered or improperly mounted, spray of liquids or process material from
improperly filled molds and tooling.
•
NEVER pump the manual jack handle without first verifying that the press base bolster has been securely
mounted to a suitable work surface to avoid the potential of the press tipping over while the jack is being
pumped.
•
NEVER attempt to open the electrical enclosure of presses equipped with electrically heated platens
without first verifying the electrical power has been disconnected and locked out. This will avoid the
hazard of electrical shock. Access to electrical control components should only be authorized to trained
maintenance personnel following approved procedures.
Before you start the press, check the following:
•
remove all maintenance crew equipment from the press area;
•
make certain safety blocks are removed from the mold;
•
be sure no objects (tools, nuts, bolts, clamps, bars) are laying in the press clamp area;
•
carefully look for obstructions left in the mold;
•
If your press has been inoperative or unattended, even for a moment, check all settings before starting the
next cycle.
•
If your press has multiple platens, be sure ALL floating platens are completely open before reaching into
the clamp area.
•
At the beginning of your shift and after breaks, cycle the press several times to verify that the controls,
press parts, molds and auxiliary equipment are functioning properly.
• Keep all safety guards in place and in good repair. NEVER attempt to bypass, modify, or remove safety
guards. Such alteration is not only unsafe, but will void the warranty on your equipment.
•
When changing press control settings to perform a different mode of operation, be sure selector switches
are correctly positioned. Test cycle the press to verify it will operate as planned. Locking selector
switches should be adjusted only by authorized persons and the keys removed after setting.
•
Do not talk to others while operating a press. If you must talk, stop the press and step away from it until
the conversation is completed.
•
DAILY clean the press and surrounding area, and inspect the machine for loose, missing, or broken parts.
•
Shut off power to the press when it is not in use. Lock the control panel or disconnect switch in the OFF
position or unplug press from power source.
Report the following occurrences IMMEDIATELY:
unsafe operation or condition
unusual press action
leakage
improper maintenance
2-3 Carver Inc