TaoTronics TT-AP003 - Air Purifier Manual

TaoTronics TT-AP003 - Air Purifier Manual

Also See for TT-AP003:

Advertisement

TaoTronics TT-AP003 - Air Purifier Manual

IMPORTANT SAFETY INSTRUCTIONS

BEFORE USING THIS APPLIANCE READ ALL INSTRUCTIONS AND CAUTIONARY MARKINGS IN YOUR USER GUIDE AND ON THE APPLIANCE
When using electrical appliances, basic precautions should always be followed to reduce the risk of f ire, electric shock, and injury to persons, including the following:

  • Read all instructions before using the appliance.

  • This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to f it in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not f it, contact a qualif ied electrician. Do not attempt to rig this safety feature.
  • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by person responsible for their safety.
  • To avoid fire or shock hazard, plug the appliance directly into a right AC electrical outlet.
  • Keep the cord out of heavy traff ic areas. To avoid f ire hazard, NEVER put the cord under rugs, near heat registers, radiator, stoves, or heaters.
  • To protect against electrical hazards, DO NOT immerse in water or other liquids. Do not use near water.
  • Children cannot recognize the hazards associated with the usage of electrical appliances. For this reason, always supervise children when they are near the unit.
  • Always unplug the air purif ier before moving it, opening the grille, changing f ilters, cleaning or whenever the air purif ier is not in use. Be sure to pull by the plug, not the cord.
  • NEVER drop or insert any objects into any openings.
  • DO NOT run the cord under carpeting.
  • DO NOT cover the cord with throw rugs or similar coverings.
  • DO NOT route the cord under furniture or appliances. Arrange the cord away from traff ic area and where it will not be tripped over.
  • DO NOT operate any appliance with a damaged cord or plug, if the motor fan fails to rotate, after the appliance malfunctions, or if it has been dropped or damaged in any manner. Send to Customer Service for assistance.
  • Use appliance only for intended household purposes as described in this manual. Any other use is not recommended that may cause f ire, electric shock, or injury to persons.
  • DO NOT place anything on top of the unit.
  • NEVER block the air openings, grille / outlets or place the unit on a soft surface such as a bed or sofa, as this could cause the unit to tip over, blocking the air inlet or outlet.
  • DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your warranty. The inside of the unit contains no user serviceable parts. All servicing should be performed by qualif ied personnel only.
FOR HOUSEHOLD USE ONLY
READ AND SAVE THESE INSTRUCTIONS

Specifications

Model TT-AP003
Operating Voltage 220-240V~50/60 Hz
Rated Power 36 W
Noise 55 dB (High Speed)

Knowing Your Air Purifier

Knowing Your Air Purifier Step 1
Knowing Your Air Purifier Step 2

Getting Started

  1. Open Air Inlet Grill.
    GETTING STARTED Step 1
  2. Press down U-shaped snap joint to take out Pre-Filter.
    GETTING STARTED Step 2
  3. Hold pull tabs to take out HEPA Filter.
    GETTING STARTED Step 3
  4. Remove from its plastic packaging.
    GETTING STARTED Step 4
  5. Place HEPA Filter back (pull tabs facing out).
    GETTING STARTED Step 5
  6. Align the slots and install Pre-Filter back.
    GETTING STARTED Step 6
  7. Align the slots and buckle up Air Inlet Grill
    GETTING STARTED Step 7
  8. Place the unit on a firm, level and flat surface.
    GETTING STARTED Step 8

Using Your Air Purifier

Control Panel

Control Panel

LED Display Screen

LED Display Screen

Quick Start of Your Air Purifier

  1. Plug into an appropriate electrical outlet.
    Quick Start Step 1
  2. Tap to turn ON the air purifier.
    Quick Start Step 2
  3. Tap to activate Auto Mode, the fan speed will be adjusted intelligently.
    Quick Start Step 3
  4. Tap to turn OFF when finished using it.
    Quick Start Step 4

Operation and Functions

Auto Mode

  • Tap to activate Auto Mode.
    Auto Mode
  • When Auto Mode is enabled, the fan speed is adjusted intelligently according to the air quality.

Memory Function

The air purifier will always remember your last settings (except timer) when turned off, and will resume these settings when it is turned back on.

Sleep Mode

  • Tap to activate Sleep Mode.
    Sleep Mode
  • When Sleep Mode is enabled, the air purifier will run quietly under lowest possible fan speed, making it ideal for use while sleeping.

Fan Speed Control

  • Tap repeatedly to cycle through the adjustable fan speeds: 1, 2, and 3 (Low, Medium, and High).
    Fan Speed Control
  • \When adjusting the fan speed under Auto or Sleep Mode, the Auto or Sleep Mode will be

Auto OFF Timer

  • Tap repeatedly to select the desired auto off time (1, 2, 4 or 8 hours).
    Auto OFF Timer
  • When time reaches zero, the air purifier will go into standby mode.
  • To cancel, tap repeatedly to select 0 hour.

Child Lock

  • Press and hold for 3 seconds to turn on or off the Lock function.
    Child Lock

Replacing the HEPA Filter

  1. will light up as a reminder to change the HEPA Filter.
    Replacing the HEPA Filter Step 1
  2. Unplug the air purifier. Remove the old HEPA Filter and properly dispose of ot.
    Replacing the HEPA Filter Step 2
  3. Replace with a new one. Install the filters and air inlet grill back.
    Replacing the HEPA Filter Step 3
  4. Plug in and tap to turn on the air purifier.
    Replacing the HEPA Filter Step 4
  5. Press and hold for 3 seconds to reset HEPA Filter.
    Replacing the HEPA Filter Step 5

NOTE:


  • Always make sure the air purifier is turned off and unplugged before replacing the filter.
  • It is recommended to replace the HEPA filter every 6 to 8 months (depending on the frequency of use and air quality).

Cleaning and Maintenance


Always make sure the air purifier is turned off and unplugged before cleaning.

Cleaning the Air Purifier Body

Outer Surface
Wipe with a soft, dry cloth. If necessary, wipe with a damp cloth, then immediately dry.
Cleaning the Air Purifier Body Step 1 Cleaning the Air Purifier Body Step 2
Cleaning the Air Purifier Body Step 3

Air Inlet Grill
Open air inlet grill, vacuum up dust with a vacuum cleaner or wipe it with a cloth.
Air Inlet Grill Step 1Air Inlet Grill Step 2

Air Outlet Grill
Remove air outlet grill, vacuum up dust with a vacuum cleaner or wipe it with a cloth.

NOTE:

  • DO NOT stick any foreign objects or your fingers inside of the unit.
  • Never immerse the air purifier in water and never allow water to drip into the motor housing.
  • For storage, you may leave the unit covered to protect it from dust. Store it in a cool, dry location.

Cleaning the Pre-Filter

  1. Unplug the air purifier. Take out the Pre-Filter.
    Cleaning the Pre-Filter Step 1
  2. Vacuum the dust or wipe it with a cloth.
    Cleaning the Pre-Filter Step 2
  3. For heavy dust, soak with diluted common kitchen detergents for 10 minutes, and then clean.
    Cleaning the Pre-Filter Step 3
  4. Dry the Pre-Filter.
    Cleaning the Pre-Filter Step 4
  5. Install the Pre-Filter and air inlet grill back.
    Cleaning the Pre-Filter Step 5

NOTE:

  • It is recommended to clean the Pre-Filter at least once every two weeks. More frequent cleaning may be required depending on frequency of use and air quality.
  • DO NOT clean with abrasive chemicals or flammable cleaning agents.

Troubleshooting

The following troubleshooting guide addresses the most common problems. If problems persist, feel free to contact the Customer Support at support@taotronics.com.

Problem Possible Causes Solution

Error Codes on LED Display


  • Disassembly Protection

  • Sensor Failure

  • Abnormal Fan Speed
  • Properly install all parts (Filters and Air Inlet Grille)
  • Contact TaoTronics Support Team.
  • Contact TaoTronics Support Team.

Filter Change Indicator does not turn off

  • The air purifier has been reset incorrectly.
  • Replace the filter and reset by pressing and holding the Timer Button for 3 seconds.

Air purifier does not power on or respond to button controls

  • Unit is not plugged in or the power socket is not switched
  • Power socket is not working properly.
  • Power cord is damaged.
  • Air purifier is malfunctioning
  • Connect the plug to a powered electrical outlet.
  • Try plugging the air purifier into a different outlet.
  • Immediately stop using and contact TaoTronics Support Team.
  • Contact TaoTronics Support Team.

Insufficient air flow

  • Fan speed is on low setting.
  • Filter packaging has not been removed.
  • Not enough free space around the unit.
  • Filter is clogged and not replaced.
  • Press Fan Speed Button to adjust the fan speed.
  • Remove the filter from its packaging before use.
  • Leave 15 in / 38 cm of clearance for proper air flow.
  • Replace the filter.

Poor air purification quality

  • Room size exceeds the expected size the unit covers.
  • Air intake or outlet is blocked. Filter is not properly placed inside the housing.
  • Filter is dirty and cannot produce fresh air anymore.
  • Not enough free space around the unit.
  • Select the right air purifier as per the actual room size.
  • Remove objects blocking air intake or outlet.
  • Properly place the filter (see Replacing the HEPA Filter).
  • Replace the filter (see Replacing the HEPA Filter).
  • Leave 15 in / 38 cm of clearance for proper air flow.

Excessive noise

  • Filter packaging has not been removed.
  • Foreign objects inside the unit.
  • Unit is placed on an uneven surface.
  • Remove the filter from its packaging before use.
  • Immediately discontinue use and contact TaoTronics Support Team. DO NOT attempt to open the air purifier.
  • Place the unit on a level and flat place.

Producing an unpleasant odor

  • Filter is dirty and cannot produce fresh air any more.
  • High humidity levels have caused mildew to grow on the filter.
  • Replace the filter (see Replacing the HEPA Filter).
  • Replace the filter, and move the air purifier to a room where the relative humidity is less than 85% RH.

Warranty and Service

Thanks for choosing TaoTronics Air Purifier. This product is covered with TaoTronics product and labor warranty for 12 months from the date of its original purchase.

Additional Half-Year Warranty
Extend your warranty to 18 months by registering your new product on our website taotronics.com/warranty

The warranty will not apply in cases of:

  • Accident, misuse, or repairs performed by unauthorized personnel.
  • Any unit that has been tampered with or used for commercial purpose.
  • Normal wear and tear of wearable parts.
  • Use of force, damage caused by external influences.
  • Damage caused by non-observance of the User Guide, e.g. connection to an unsuitable mains supply or non-compliance with the instructions.
  • Partially or completely dismantled appliances.
  • Defects caused by or resulting from damages from shipping or from repairs, service, or alteration to the product or any of its parts that have been performed by a repair person not authorized by TaoTronics.

We can only provide after sales service for products that are sold by TaoTronics or TaoTronics authorized retailers and distributors. If you have purchased your unit from a different place, please contact your seller for return and warranty issues.
* Please have your invoice and order ID ready before contacting Customer Support.


TaoTronics
Model TT-AP003

SUPPORT

Should your product prove defective within the specified warranty period, or any questions regarding warranty or service, email us at support@taotronics.com.

Default Warranty Period 1 Year
Extend your warranty to 18 months at taotronics.com/warranty
Order ID
Date of Purchase
Purchased From

E-mail:
support@taotronics.com

MANUFACTURER
Manufacturer: Shenzhen NearbyExpress Technology Development Co.,Ltd. Address: Floor 7, Building E, Galaxy World Phase II, Shenzhen, China

Learn more about the EU Declaration of Conformity:
https://www.taotronics.com/pages/user-manual

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download TaoTronics TT-AP003 - Air Purifier Manual

Advertisement

Need help?

Need help?

Do you have a question about the TT-AP003 and is the answer not in the manual?

Questions and answers

Table of Contents