Nitroset NTS805 Series Quick Start Manual

Required Safety & Protective Equipment
Always wear proper safety e uipment including safety glasses, hard hats,
hearing protection, and gloves while operating the tool.
Check Before Fastening
Check the thickness and type of base material before fastening. Follow your
Minimum concrete thickness is three times the fastener penetration
(ie. 3" of concrete base material is a minimum requirement for 1"
penetration).
In fastening into steel substrate, the minimum thickness of substrate must
be 3/16".
Acceptable Base Materials
The NITROSET® tool is for fastening into the following base materials only:
Concrete
Structural Steel
Never attempt to fasten into any material other than those listed above.
Adapter Installation
Red Nosepiece
Reset Reset
Adapter Gasket
Sleeve Sleeve
Note: As illustrated above, Nosepiece Gasket is inserted in the groove of the
Note: As illustrated above, the Red Adapter is installed between the Muzzle Note: As illustrated above, the Red Adapter is installed between the Muzzle
Muzzle. Debris Cup Gasket goes between the Muzzle and Debris cup. The Red
and Reset Sleeve. and Reset Sleeve.
Adapter is installed between the Muzzle and Reset Sleeve.
Remember to read the NTS805 Series Operation & Safety Manual for detailed
procedures of troubleshooting, tool assembly, disassembly and cleaning.
NTS805 Series Quick Start Guide
Muzzle
Red Red
Muzzle Muzzle
Adapter Adapter
W W W . N I T R O S E T . C O M
Debris Cup Debris Cup
Debris Cup Debris Cup
Gasket
1