Reversing The Doors - Yamato RFC201 Instruction Manual

The doors can be changed from right-hinged to left-hinged and vice versa as follows:
1. Lay the upper hinge.
appliance on its 3. Move the plastic plugs to where the
back with the upper hinge was fitted.
doors 4. Lift off the upper door and lay it aside.
uppermost. 5. Remove the middle hinge by
2. Remove the unscrewing the screws.
9. opposite side of the appliance.
R 10. Refit the kick plate
emove the 7. Remove the kick plate by pulling it
lower outwards and upwards.
hinge. 8. Loosen lock nut with the fork
Rotate the wrench enclosed and move the
hinge pin.
through 11. Remove the door-closer and refit
180° and it on
refit it on the opposite side.
the 12. Remember to pull the pin in the
15. Remove the tight seal all
door handles the way
and refit round.
them on the If it
opposite does not,
side. carefully
Refit the heat the
caps. strip all the
16. The way round
appliance using a hair
must be dryer. Then
allowed to ease the
stabilise in an strip
upright outwards
position for at slightly so
least 1 hour that it forms
before being a tight seal
switched on. against the
17. After cabinet. Be
reversing the careful not
door(s), it is to heat the
important to strip so
check that the much that it
sealing strip melts!
provides a

Reversing the Doors

6. Lift off
the lower
door and
lay it aside.
door closer
towards
the side
before
fitting the
door.
13. Fit the
upper door.
14. Fit the
upper hinge.