Installation Instructions - Eagle Group CLHP-2-NG Operating & Installation Instructions Manual

Countertop Gas Hot Plates
• IMPORTANT: INSTALLATION MUST CONFORM TO THE NATIONAL FUEL GAS CODE #ANSI Z223.1-1996,
THE NATIONAL GAS INSTALLATION CODE #CAN/CGA-B149.1, OR THE PROPANE INSTALLATION CODE
#CAN/CGA-B149.2 AS APPLICABLE AND IN ACCORDANCE WITH LOCAL CODES.
• Gas connection to the hot plate must be performed by a technician certified or licensed to install gas-fired equipment.
• Installation of this gas-fired appliance must comply with applicable portions of NFPA 96 for ventilation.
• If legs are not in place, screw all legs into permanently fastened nuts on all corners and tighten by hand. Use leg
adjustment to level the hot plate.
• Clearances:
For use on noncombustible surface only: 6˝ sides, 6˝ rear
• All gas hot plates are supplied with a gas pressure regulator suitable for use with natural gas or LP gas as noted on
the name plate. Check rear mounted plate to verify type of gas.
1) Connect hot plate to gas supply by pipe material that's approved by local ordinance for gas piping.
2) Apply sealant to male threads only. Sealant must be resistant to the action of liquefied petroleum gases.
CAUTION: Do not use an open flame to check for leaks. Check all gas piping for leaks with a soap and water
solution before operating unit.

INSTALLATION INSTRUCTIONS

GENERAL NOTES
INSTALLATION
5
(continued on Page 6)