Table of Contents
Advertisement
Quick Links
Item# 50857N
HYUTT33001-1
Model#
Note: A table with an umbrella hole (not included)
is required to assemble this product.
WARNING: If the information in this
manual is not followed exactly, a fire or
explosion may result causing property
damage,personal injury,or loss of life.
WARNING
Improper installation, adjustment, alteration, service or maintenance can cause injury or
property damage. Refer to the owner's information manual provided with this appliance.
For assistance or additional information consult a qualified installer, services agency or
the gas supplier.
INSTALLER:
Leave this manual with the appliance.
CONSUMER:
Retain this manual for future reference.
20 IN TableFire Gas Fire bowl
Owner's Manual
®
DANGER
FIRE OR EXPLOSION HAZARD
If you smell gas:
Shut off gas to the appliance.
Extinguish any open flame.
If odor continues, leave the area immediately.
After leaving the area, call your gas supplier
or fire department.
Failure to follow these instructions could
result in fire or explosion, which could cause
property damage, personal injury, or death.
WARNING
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance. An LP-cylinder not connected
for use shall not be stored in the vicinity of
this or any other appliance.
WARNING
Installation and service must be performed
by a qualified installer, service agency,
or the gas supplier.
For outdoor use only.
Advertisement
Table of Contents
Related Manuals for Bond 50857N
Summary of Contents for Bond 50857N
- Page 1 ® 20 IN TableFire Gas Fire bowl Item# 50857N DANGER HYUTT33001-1 Model# FIRE OR EXPLOSION HAZARD If you smell gas: Shut off gas to the appliance. Extinguish any open flame. If odor continues, leave the area immediately. After leaving the area, call your gas supplier or fire department.
-
Page 2: Safety Information
Keep a safe distance to avoid burning skin or clothing. Do not sit or rest hands or feet on this heating unit. Keep all electrical cords and fuel supply hose away from heated surfaces. Bond Manufacturing Co., Inc. | Page 2... - Page 3 Combustible material should not be within 60 inches of the top of the unit, or within 48 inches around the entire unit. Keep the appliance area clear and free fr vapors and liquids. Do not add water into the unit. Do not operate unit if any part has been under water.
- Page 4 Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate the appliance. For assistance with repair or replacement of the burner or any other parts, calls Bond Manufacturing Co., Inc. at 1.866.771.2663.
- Page 5 CONTENTS Item Description Firebowl Body Electronic Igniter (within firebowl insert body) Fixing Plate Fixing Nut (preassembled) Quick Disconnect Connection (male end) Quick Disconnect Connection (female end) Regulator and Hose Battery (AA) Tank Holder Burner (preassembled) Guard (preassembled) Ignition Control Knob (preassembled) ®...
- Page 6 3. Unscrew and remove the fixing nut (D) from the threaded post, then attach the fixing plate (C) onto the bottom of the firebowl body (A) using 4 M4 screws (N). Be sure to tighten securely. Bond Manufacturing Co., Inc | Page 6...
- Page 7 4. Insert the threaded post into the umbrella hole on the tabletop so that the bottom of the firebowl body (A) sits flush on the tabletop. Secure the firebowl body (A) to the table by screwing the fixing nut (D) onto the threaded post underneath the tabletop.
- Page 8 Keep away from the unit and allow the unit to burn 20 minutes for the first time use. Always ensure that lava rocks/pumice stones/ LavaGlass ® are completely dry before use. Failure to do so will cause them to crack or pop. Bond manufacturing Co., Inc. | Page 8...
-
Page 9: Operation
OPERATION Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor area. Connect the propane gas tank to the regulator and turn the valve on the unit to the “off” position. Brush a soap and water mixture on all connections. Turn the gas supply on; if bubbles occur on any connection there may be a leak. -
Page 10: Maintenance
If storing this unit inside, disconnect the propane gas tank from the gas valve. Not using manufacturer approved or supplied parts/accessories may result in a defective condition and void the warranty of this heating unit. rotective cover on heating item when not in use. Bond manufacturing Co., Inc. | Page 10... -
Page 11: Troubleshooting
Igniter battery is incorrectly inserted Check which direction the battery is inserted Igniter pin is broken Contact Bond Manufacturing Co., Inc. for Heating unit won’t light a replacement part Electrode wire is loose or disconnected Reconnect wire to the igniter box located... -
Page 12: Warranty
Use and installation other than what is listed in this manual. Please contact the manufacturer for replacement parts. CONTACT If you have any questions or concerns, please contact Bond Manufacturing Co., Inc. at the below resources: Toll Free Phone 1-866-771-BOND (2663) | Monday - Friday, 8am - 4:30pm PST Email customer.service@bondmfg.com...