Page 1
R ed E m ber Glac ier S tone 6 0 I N Gas Fire Table Item# 668 61 Model# BH7001-48 DANGER If you smell gas: 1. Shut off gas to the appliance. 3. If odor continues, keep away from the appliance and immediately call e department.
• Keep a safe distance to avoid burning skin or clothing. • Do not sit or rest hands or feet on this heating unit. • • Keep all electrical cords and fuel supply hose away from heated surfaces. Bond Manufacturing Company | Page 2...
Page 3
• Combustible material should not be within 72 inches of the top of the unit, or within 48 inches around the entire unit. • Keep the appliance area clear and free from combustible material, gasoline and other flammable vapors and liquids. •...
Page 4
Bond Manufacturing Co. Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate the appliance. For assistance with repair or replacement of the burner or any other parts, call Bond Manufacturing at 1.866.771.2663.
CONTENTS Item Description Lava rocks 1 box Battery Body Tank Holder Protective Cover Control Knob (preassembled) Electronic Igniter (preassembled) Burner (preassembled) Guard (preassembled) Feet (preassembled) 1-866-771-2663 | Page 5...
Page 6
CYLINDER VALVE by turning the regulator coupling nut BLACK COUPLING NUT BLEED-OFF clockwise. Make sure it is fastened turn clockwise to connect VALVE securely and tighten connections by hand turn clockwise only. REGULATOR to reseal Bond Manufacturing Company | Page 6...
Page 7
4. Remove the rubber cap on the electronic igniter (G) by unscrewing and slide battery (B) into the battery slot. Make sure the positive side of the battery faces outwards. Screw the electronic igniter cap (G) over the battery tightly. 5.
2. Close the cylinder valve on the propane gas tank if you don’t intend to use it for a long time. WARNING Fire product and propane gas cylinder minimum distance must be over 60 inches (as per right side photo) Bond Manufacturing Company | Page 8...
MAINTENANCE • Before performing any maintenance always disconnect propane gas tank. • Keep the heating item free and clear from combustible materials. • Visually inspect burner for obstructions and keep tank enclosure free and clear from debris. • Use a soft brush to get rid of the mild stains, loose dirt and soil after the burner and pumice stones/ lava rocks/LavaGlass™...
Electrode wire is loose or disconnected Reconnect wire to the igniter box located inside the table behind the igniter box Electrode wire is shorting between valve Contact Bond Manufacturing for a re- and igniter pin placement part No gas flow Check that the gas tank isn’t empty...
• Use and installation other than what is listed in this manual. Please contact the manufacturer for replacement parts. CONTACT If you have any questions or concerns, please contact Bond Manufacturing Company at the below resources: Toll Free Phone 1-866-771-BOND (2663) | Monday - Friday, 8am - 4:30pm PST Email customer.service@bondmfg.com...
Mesa de Fuego a Gas Red Ember Glacier Stone, 152 cm (60 pulg) No. de artículo 668 61 PELIGRO No. de modelo BH7001-48 Si percibe olor a gas: 1. Cierre el suministro de gas hacia el electrodoméstico. 2. Apague cualquier llama expuesta.
• El aparato puede estar caliente al usarlo; no intente moverlo mientras esté en uso. • Nunca deje este aparato de calefacción sin vigilancia durante el uso. • Este aparato no está diseñado para cocinar. • Bond Manufacturing Company | Page 14...
Page 15
• Manténgase a una distancia segura para evitar la quema de la piel o de la ropa. • No se siente ni descanse las manos o los pies en este aparato de calefacción. • Nunca ponga las manos o los dedos en la parte superior de este aparato durante el uso. •...
Page 16
Utilice únicamente el regulador y el ensamblaje de manguera provistos con este aparato. Las piezas de repuesto deben ser proporcionadas directamente por Bond Manufacturing Co. Revise el quemador antes del uso de este aparato. Si el quemador presenta daños de cualquier tipo, no utilice el aparato.
Page 17
CONTENIDO Artículo Descripción Cant. 1 caja R ocas de lava Pila Cuerpo Soporte de tanque Funda protectora Botón de control (premontado) Encendedor eléctrico (premontado) Quemador (premontado) Dispositivo de seguridad (premontado) Patas (premontadas) 1-866-771-2663 | Page 17...
TUERCA DE CONEXIÓN NEGRA VÁLVULA horario. Asegúrese de que esté bien gire en sentido horario para conectar DE PURGA gire en sentido solamente. REGULADOR horario para volver a cerrarla Bond Manufacturing Company | Page 18...
Page 19
4. Retire el capuchón de goma del encendedor eléctrico (G) destornillándolo y deslice la pila (B) en el compartimiento de la pila. Asegúrese de que el lado positivo de la pila esté hacia el exterior. Enrosque bien el capuchón del encendedor eléctrico (G) sobre la pila.
Cuando el quemador está en funcionamiento debe retirarse la cubierta. La distancia mínima del cilindro de gas propano y bol de fuego debe ser superior a 60 pulg (según foto de la de recha). Bond Manufacturing Company | Page 20...
MANTENIMIENTO • Antes de hacer cualquier mantenimiento, desconecte siempre el tanque de gas propano. • Mantenga el aparato de calefacción despejado y libre de materiales combustibles. • Visualmente revise el quemador para obstrucciones, y mantenga el encerramiento del tanque despejado y libre de residuos. •...
Ningún flujo de gas Compruebe si el tanque de gas esté La llama se apaga vacío facilmente El dispositivo de seguridad de exceso de Ver ‘Caída repentina del flujo de gas’ flujo se ha activado arriba Bond Manufacturing Company | Page 22...
Page 23
• Uso y instalación con fines ajenos a los indicados en las instrucciones de este manual. Póngase en contacto con el fabricante para obtener piezas de repuesto. PONERSE EN CONTACTO Si tiene alguna pregunta o preocupación, póngase en contacto con Bond Manufacturing a los recursos abajo: Teléfono sin cargos 1 866 771-BOND(2663) de lunes a viernes, de 8.00 a 16.30 PST...
Need help?
Do you have a question about the BH7001-48 and is the answer not in the manual?
Questions and answers