Siemens WT45W561OE Installation And Operating Instructions Manual page 26

Table of Contents

Advertisement

Programme settings
en
(Finish in) 5
Антисмин. 60'
(Anticrease 60) Ý
Антисмин. 120'
(Anticrease 120) Ý
Пониж. темп.
(Low heat) s
Сигнал (Signal) V
--------
26
‚ - ƒ...
Before starting the programme, you can preselect the pro-
gramme end time ("Ready in" time) in hourly increments (h =
hour), up to a maximum of 24 hours:
Select a programme.
1.
The programme duration will be displayed for the selected
programme, e.g. ‚:...† (hours:minutes).
Press (Finish in) 5 repeatedly until the required number
2.
of hours is displayed.
Note:
ting values, and the (Finish in) 5 – button to reduce
them.
3.
Press (Start/Pause) Ü.
This activates the time delay.
Before the programme starts, the selected number of
hours (e.g. ‰) is shown on the display and counts down
until the drying programme starts. The duration of the pro-
gramme will then be displayed.
Note:
time.
E.g. û ‹ : ...‹ The drying time for timed programmes can be extended to up
to 3 hours 30 minutes in 10-minute increments.
The drum moves the laundry at regular intervals after drying to
prevent creasing. You can extend the automatic Anti-Crease
function by 60 minutes (by pressing Антисмин. 60'
(Anticrease 60) Ý) or 120 minutes (by pressing Антисмин.
120' (Anticrease 120) Ý) after any programme has finished.
Reduced temperature for delicate fabrics, e.g. polyacrylic or
elastane; may increase the drying time.
Use the Сигнал (Signal) V button to activate or deactivate the
audible signal that sounds to indicate that the programme has
ended. If the setting has been selected, the button's indicator
light will be lit and the signal tone is activated.
Use the (Finish in) 5 + button to increase the set-
The programme duration is included in the "Ready in"

Advertisement

Table of Contents
loading

Table of Contents