Table of Contents
Advertisement
Quick Links
Wolff
vanity unit
Recommended installation guide
Contents
Once you have everything out of the box, you will have:
- 2 x shelves (top & bottom)
- 2 x angles (one affixed to each shelf) please note that
the centre is marked on each angle
- 2 x legs with screw jack feet, protected with shrink
wrap - please note the shrink wrap must be left on the
leg until legs are installed
- 4 x screws for affixing angles to shelves
What you need
- pencil
- measuring tape
- level
- drill with #2 square drive
- 4 x suitable wall fixings (e.g. wall plugs for masonry,
adequate timber screws for studs)
- a drill bit suitable to your wall fixings
- a counter-sink bit suitable to your wall fixings
Installation
Your Wolff vanity unit must be fixed to appropriate
fixing points in your wall, ie:
- studs
- blocks
- brick
hello@woodmelbourne.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for WOOD Wolff
Summary of Contents for WOOD Wolff
- Page 1 - a drill bit suitable to your wall fixings - a counter-sink bit suitable to your wall fixings Installation Your Wolff vanity unit must be fixed to appropriate fixing points in your wall, ie: - studs - blocks - brick hello@woodmelbourne.com...
- Page 2 Wolff vanity unit Installation steps 1. Choose the location for your Wolff vanity unit 3. Check your floor for level by placing the level along 2. Measure the width of your vanity unit and mark the the floor approximately where the feet will go centre line onto the wall 4.
- Page 3 Wolff vanity unit 5. Mark the leg height measurement onto the wall - note: 7. Find adequate fixing points on your wall and mark measure from the highest point of the floor level. This these onto your angle - note: ensure the centre mark on is where the underside of the lower shelf angle will be the angle aligns with the centre line on the wall.
- Page 4 Wolff vanity unit 9. Use your counter-sink bit to counter-sink the fixing 11. Gently slide legs through lower shelf - note: discs holes on the angle. must sit on the under side of the shelf. Be careful not to 10. Affix the angle to the wall - note: the angle must sit remove the protective wrap.
- Page 5 Wolff vanity unit 12. Use #2 square drive to fix shelf onto angle. 14. Measure from top of shelf to top of leg. 13. Level shelf using screw jack feet (clockwise = higher, anti-clockwise = lower). hello@woodmelbourne.com...
- Page 6 Wolff vanity unit 15. Measure inside the round notch-out on the underside 16. Deduct the notch height from the leg height and of the top shelf (approx 10-12mm). mark this height on the wall - note: use your level to mark the line.
- Page 7 Wolff vanity unit 17. Mark the fixing points onto the angle and drill out 19. Gently remove the protective leg covers. and countersink holes. 20. Fit the top shelf onto angle and legs. 18. Affix the angle to the wall - note: remember to align 21.
Need help?
Do you have a question about the Wolff and is the answer not in the manual?
Questions and answers