Advertisement
3.11. After your command is accepted, wait for the beep and say the number of your dealership in the list of nearest
dealers.
3.12. After your command is accepted, wait for the beep and say "Set as destination."
3.13. Follow the voice guidance back to your dealership. It should work even with the audio system turned off.
3.14. Make sure the time shown in the navigation display is correct; the system gets it from the GPS satellites. For
areas that do not follow daylight saving time, you may have to adjust the time settings. Select Settings, Clock
Adjustment , and set Auto Daylight to OFF.
NOTE: If your dealership is near a time zone boundary, set Auto Time Zone to OFF. The clock then keeps the
home time zone if the client routinely drives across the time zone boundary.
3.15. If your dealership is in an area that has traffic incident or traffic flow data available (see ACURALINK REAL-TIME
TRAFFIC INFORMATION) , do this:
•
Select the map scale icon, then select between the 1/20- to 5-mile scales using the + and - icons.
•
Scroll and center on the downtown area of your city. If your metro area has traffic flow data, freeways and
other main roads should show this data as red, yellow, or green lines in one or both directions.
•
You may see small, diamond-shaped traffic incident icons. If so, scroll over the icon and select it to see the
details.
•
Partially shown traffic data does not mean there is a problem with the navigation system. Traffic flow and
density varies from day to day and from one road to another. If your area has traffic, but you cannot see it on
the screen, do a search in the service information using keyword TRAFFIC.
3.16. Clear any information that was saved during the TQI.
•
Turn the ignition to ACCESSORY.
•
Turn on the audio-navigation unit.
•
From the Home screen, select Settings, System, then Factory Data Reset. A confirmation screen appears.
•
Select Continue. A second confirmation screen appears.
•
Select Continue. The system resets.
4.
REARVIEW CAMERA
With the ignition turned to ON, shift to Reverse. The rearview image appears on the navigation screen. Make sure the
distance guidelines appear as well. Change the camera views by pressing the CAMERA button. If the image is foggy or
dirty, clean the camera lens.
5.
SURROUND VIEW CAMERA (ADVANCE TRIM LEVEL ONLY)
With the ignition turned to ON, press the CAMERA button. The front view image appears on the navigation screen.
Make sure the distance guidelines appear as well. Press the CAMERA button again to switch to another camera view. If
the image is foggy or dirty, clean the camera lenses. To exit the surround view camera system, press another mode
button (Nav, INFO, PHONE, or SMARTPHONE).
6.
TROUBLESHOOTING
If you think you have found any problems with the navigation system during the TQI or after installing replacement parts
to repair it, go to the service information and enter keywords HOW TO TROUBLESHOOT. From the list, select How to
Troubleshoot the Navigation System. This helps you to avoid replacing parts when the issue may just be a system
characteristic
Page 5 of 6
Advertisement
