Advertisement
Since the navigation system interfaces with other vehicle systems, it is important that all of the systems are initialized. To
initialize the navigation system, follow these steps:
3.1. Do the regular TQI of the vehicle.
3.2. Turn the ignition to ON.
NOTE: You may see the factory InLine Diagnostics screen below, which means the audio-navigation unit is in the
factory diagnostic mode. If you do, follow these steps to exit the mode; otherwise, skip them, and go to step 3.3.
Select Start Diag.
•
•
Press and release all of the buttons on the steering wheel that are shown in the InLine Diag screen. The
icons should turn green.
•
Press and release the Talk button. Make a loud sound (like snapping your fingers or clapping your hands) or
say "Testing" in a normal voice toward the microphone in the ceiling console. The mic level indicator should
reach at least six bars.
•
When you have completed all of the tests, the icons will be green. If any of them are red, troubleshoot the
applicable system. Refer to the service information. Select Exit Diag to exit the mode.
•
If you see this screen, it means battery power has been lost. Touch and hold the Power/AUDIO icon for more
than 2 seconds to enable the system.
•
You will then see this screen. Select OK.
NOTE: Selecting OK is optional; the screen will change on its own.
3.3. Start the engine, and park the vehicle in an open area away from trees, power lines, and tall buildings. Remove
loose articles, cell phones, and electrical accessories near the GPS antenna. Press the VOL/Power AUDIO knob
to turn on the audio-navigation unit. When the Enter Code screen appears, press and hold the knob for about 2
seconds. This lets the PCM check that the vehicle's VIN matches the one saved in the unit. You will hear a long
beep when the unit exits the anti-theft mode. Release the knob.
Page 3 of 6
Advertisement
