Changing The Display Pattern; Canceling The Display Demonstration - JVC KD-LH1000 Instructions Manual

Changing the display pattern

You can change the display pattern.
The number of the selectable display patterns
varies according to the playback sources.
However, the unit basically provides three main
display patterns for each source, and once one of
these three patterns is selected, the same
pattern is used for all the sources.
Press DISP (D).
Each time you press the button,
the display patterns change as
follows.
Ex.: When playing a CD
Large animation
display
Small animation
displays*
Clock time
display
* Small animation displays are used for showing
not only the source's main information
(illustrated on this page as examples), but also
showing some other information. For details, see
each related section.
In this manual, the illustrations of the display are
mainly of the large animation display (initial
setting). If you have changed the display patterns
or some PSM items, the actual displays you see
will be different.
Note:
While playing a source, you can also show the level
meter on the display. For details, see "Activating the
level meter" on page 21.
8
Canceling the display
demonstration
When shipped from the factory, display
demonstration (MovieDemo) has been activated,
and starts automatically when no operations are
done for about 20 seconds.
• It is recommended to cancel the demonstration
before you use the unit for the first time.
To cancel the display demonstration, follow the
procedure below:
1
Press and hold SEL
(select) for more than 2
seconds so that one of
the PSM items appears
on the display.
(PSM: see page 23.)
2
Press 5 (up) or ∞ (down)
repeatedly until "Disp
(display)" is selected
as the PSM category
(it is shown on the
left side of the
display).
3
Select
"MovieDemo."
4
Select "Off."
5
Finish the setting.
To activate the display demonstration, repeat
the same procedure and select "All Time" or
"Interval" in step 4.
• For more details, see "To set movie demo—
MovieDemo" on page 23.