Eaton 10250T Instructional Leaflet

Instructional Leafl et IL04707001E
10250T contact block assembly
Lens Washer
Retaining
ILL
Nut
P .B.
IND
LIGHT
PUSH
PULL
Thrust Washer
(Optional)
Vertical Mounting
T-Line Operator
91000/E34
Earth Terminal
#755 Lamp
Operator
Gasket
Panel
Nameplate
0.063–0.250
(1.6–6.3 mm)
Use 60/75ºC Copper Conductors Only
0.136 (3.5 mm) Diameter Hole or
0.180 (4.6 mm) Rectangular Notch
0.60
(15.2 mm)
Horizontal Mounting
Effective June 2011
Saddle Clamp Type Terminals
14 AWG–22 AWG
2 2
(2.5 mm —0.34 mm )
Solid or Stranded.
Do Not Mix One or Two
Conductors per Terminal
Ratings are Stamped Assemble Master Test or
on Light Unit Flasher Modules to Rear
and Contact Block of Contact Blocks.
Wires Shown are not Included
Underwriters Laboratories Listed
•
1.20
For use on a flat surface of Type 1, 2, 3, 3R,
•
(30.5 mm)
3S , 4, 4X, 12, and 13 enclosures
IP65
•
For indicating lights without moveable operations.
General
1. Drill mounting hole for vertical or horizontal
mounting per one of the figures above.
2. Ensure sealing gasket is in place on the
operator. Align locating nib of operator
with notch in panel and insert operator
through mounting hole. Exception: See
special instruction publication 20437 for
placement of sealing gasket when using
10250T/91000T protective boots.
3. Place legend plate and mounting nut over
operator. Tighten mounting nut. If applicable,
assemble lenses, mushroom buttons, etc., to
operator. Tighten securely (5 ft-lbs) (6.8 Nm).
4. Torque terminals to 7 in-lbs (0.8 Nm).
For ease of assembly, Eaton recommends
the following tools:
10250T/91000TA95 for 10250T/91000T octagonal
•
nuts, E29, and E30 lines
E22CW for 10250T/91000T octagonal nuts,
•
E22, E34, and E30 lines
Earth/Ground
Conductor