PreCise Biometrics Precise 100 Logon 2.1 Quick Reference page 2

Installation
Connect the fingerprint reader
If you have a Precise 100 Reader with USB connector, skip this section and go to the next
page "Log on as an administrator". If you have a Precise 100 Reader with parallel port
connector, follow the instructions below.
1. Make sure that the computer has been turned off.
2. Connect the fingerprint reader to the computer as shown below.
parallel port connector
pass-through
PS/2 connector
keyboard
PS/2 connector
NOTE: The parallel port must be set to ECP
mode, otherwise the fingerprint reader will not
function properly. Please refer to the computer
manual for additional information, or follow the
instructions below.
To set the parallel port:
1. Access the system setup utility on your computer. On most computers this is done
by pressing the F1, F10, Delete or Esc key during system booting, i.e. immediately
after switching on the computer.
2. Find the parallel port mode and set it for ECP. If the ECP selection is unavailable,
the parallel port is probably already set for ECP.
3. Save your changes and exit the system setup utility.
Log on as an administrator
You must have administrator rights on your local computer to install the
Precise 100 Logon 2.1 software.
Install software
NOTE: If you have a previous release of Precise Biometrics fingerprint identification software installed on your
computer, please do the following before you install the Precise 100 Logon 2.1 software: 1) Make sure you have
a backup password (see the chapter BioManager). 2) To uninstall the old software, read carefully the chapter
Uninstalling in your Precise Biometrics manual and follow the instructions.
NOTE:
After the installation of components, you may be asked to restart your computer. Please ignore this and
restart your computer when you reach step 4 in the installation sequence.
Insert the Precise 100 Logon 2.1 software CD. The Master Setup screen will appear.