Visus DE03T Quick Start Manual

ITEM NO.: DE03
The DVI Distributor receives and reconstructs (equalizing & re-clocking) a DVI signal and
distributes it to three identical outputs. It can be perfectly cascaded with one another in order to
obtain more DVI outputs (at least 6 tiers). It will also process (read & store) the EDID information
sent over the Data Display Channel (DDC).
DE03 DVI CAT5 Extender & Distributor - 1 in 3 out
Connects a DVI video source to 3 DVI compatible displays.

3 outputs: 2 x DVI-D, plus 1 x CAT5 RJ45 output for remote side.

Each set including 1 x DE03T distributor, 1 x DE01E CAT5 receiver and 1 x 5V power

adapter.
DE01E as DVI CAT5 receiver at remote side, range up to 30 meters.

Extends 15meters

Cascade connection several units for larger displays with great picture quality.

Reads and remembers the EDID of displays.

Panel View:
DE03
DE01E
Mode
1 On Open EQ. Less noise but more power consumption.
Off Close EQ.
2 On Writing default EDID.
*Set the DIP switch at on and plug in power cord. The green LED will light after the writing
process is completed.
Off Record EDID of the connected display via DVI-OUT1
*Plug in DVI cable first from the display and then plug in power cord. The recording process
will be initiated and the green LED lights. The green LED will turn of after the reading process
is completed.
Warning!! Don't plug in DVI source while the 1X3 DVI Distributor is writing default EDID or recording
EDID from displays. This will cause damage to the EDID in the flesh memory.
If you cannot boot your computer from the connected 1X3 DVI Distributor due to the damaged EDID
in the 1X3 DVI Distributor, please proceed the "Writing default EDID" and then "Recording EDID of
the connected display". This will enforce the 1X3 DVI Distributor to write the EDID from display.
DVI CAT5 Extender 1 in 3 out
of input/output DVI cable.
Button Function