Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for DUKWIN DK01 Series
Summary of Contents for DUKWIN DK01 Series
- Page 1 DK01 SERIES WATCH WINDER MANUAL...
-
Page 2: Table Of Contents
CATALOGUE Introduction 1. Power 1.1 Optional Plug 2. The back of the watch box 3. Watch Cuff 4. How To Use The Watch Cuff 5. Controls 6. Program Setting 6.1 Winding Program for Manual Control Watch Winder 6.2 Winding Program for LCD Remote Control Watch Winder 7. -
Page 3: Introduction
Introduction Congratulations on your purchase of this watch winder. Please review this quick start guide so that your auto- matic watch will benefit fully from the features that have been engineered into this product. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or... -
Page 4: Power
1 Power 1. The models for DK018SK - DK048SK watch winders comes with a power adapter (AC/DC3.0V-volt. 1.2A output) and will also run on two "D" cell batteries. Battery Case (Package not including batteries) 2. The models for DK068SK , DK098SK, DK128SK watch winders comes with a power adapter (AC/DC5.0V-volt. -
Page 5: The Back Of The Watch Box
Note: Never use any unauthorized power adapter or not up to specification power adapter. 2 The back of the watch box LED Light Power Pause Switch Control Power Port Switch Pause Switch: When you turn on the "pause switch" and open the lid, all drums will immediately stop rotating. -
Page 6: How To Use The Watch Cuff
53mm 35mm 60mm 40mm Detachable Part 4 How To Use The Watch Cuff Step 1:Remove the cuff from the winder drum by pulling on the two tabs. Step 2: Close the strap or bracelet of your watch. Step 3: Compress the cuff, and slide your watch over the cuff, watch dial facing outward. - Page 7 Mode 3 Mode 2 Mode 4 Mode 1 on/off 2. Manual Control TPD Selection Knob design is suitable for the model DK018SK, DK028SK, DK038SK and DK048SK DK068SK DK098SK DK128SK Remote Led light Direction Control Run&Stop Selection TPD Selection Watch selection LED light control Signal LINE...
- Page 8 3. LCD Backlit The LCD backlight assists users to read the LCD. It will be activated when the power switch on, either the lid open or program have been manipulated. In order to save power, the backlight will automatically turn off when there is no input detected for about 10 seconds.
-
Page 9: Program Setting
6 Program Setting 6.1 Winding Program for Manual Control Watch Winder (Suitable for the model DK018SK, DK028SK, DK038SK and DK048SK) Mode 1: Rotate 2 minutes clockwise, rest for 6 minutes, cycle repeat Mode 2: Rotate 2 minutes counter clockwise, rest for 6 minutes, cycle repeat Mode 3: Rotate 2 minutes clockwise, rest for 6 minutes, Rotate 2 minutes counter clock-wise,rest for 6 minutes, cycle repeat... -
Page 10: Contact
Note: · Please do not remove or insert a watch during operation. · Please do not move the turntables by hand at any time. · Please make sure A/C connection is out if you don't use the watch winder for a longer time period. ·...
Need help?
Do you have a question about the DK01 Series and is the answer not in the manual?
Questions and answers