Gef-Mod-32432-Dvielr - Gefen Pro GEF-MOD-32432-DVI User Manual

CONNECTING THE 32X32 MODULAR MATRIX
GEF-MOD-32432-DVI / GEF-MOD-32432-DPDVI
1. Connect up to 32 DVI sources to the DVI inputs on the rear panel of the 32x32
Modular Matrix using DVI cables.
2. Connect up to 32 DVI displays to the DVI outputs on the rear panel of the 32x32
Modular Matrix.
3. Connect both AC power cords from the 32x32 Modular Matrix to available electrical
outlets. Connecting both AC power cords will provide redundancy should one of
the power supplies fail. It is recommended to connect each power cord to electrical
outlets on two separate circuits.
1. Connect up to 32 DVI sources to the DVI inputs on the rear panel of the 32x32
Modular Matrix using DVI cables.
2. Connect a CAT-5e cable (or better), up to 330 feet (100 meters) from each ELR-POL
jack on the Sender card to each of the included ELR-POL Receiver units, as shown
below.
Once the matrix is powered, the Link indicators will glow bright green to indicate a
solid link between the output card and the Receiver unit.
The POL indicators will glow bright amber to indicate that the Receiver unit is being
powered.

GEF-MOD-32432-DVIELR

CAT-5e cable
Up to 330 feet (100 meters)
(Continued on next page)
13