Page 1
9. USB Port 3. Power Switch 10. Communication Protection Ports 4. Power On Indicator 11. Circuit Breaker 5. Mute Button (LE850G) 12. Ground Screw 6. Fault Indicator (LE850G) 13. Outlets Designed for AC Adapters 7. Mode Switch (LE1000DG) Cyber Power Systems (USA), Inc.
PRODUCT REGISTRATION Thank you for purchasing a CyberPower product. This UPS is designed to provide unsurpassed power protection, operation, and performance during the lifetime of the product. Please take a few minutes to register your product at: www.CyberPowerSystems.com/registration. Registration certifes your product’s warranty, confrms your ownership in the event of a product loss or theft, and entitles you to free technical support.
Software Section for a free download. AUTOMATIC VOLTAGE REGULATOR The LE850G / LE1000DG stabilizes inconsistent utility power to nominal levels that are safe for equipment. Unstable utility power can be damaging to important data and hardware.
(DO NOT plug a 5. Mute Button (LE850G) laser printer, paper shredder, copier, space Press the button for 2 seconds to enable heater, vacuum cleaner, sump pump,...
1. When replacing batteries, replace with the same number of the following battery: 5. CAUTION: A battery can present a risk CyberPower / RB1270B for LE850G; of electrical shock and high short circuit CyberPower / RB1290A for LE1000DG. current. The following precautions should be observed when working on batteries: 2.
Contact CyberPower Systems The battery is worn out. about replacement batteries at: The UPS will not turn on. cyberpowersystems.com/support. Contact CyberPower Systems at: Mechanical problem. cyberpowersystems.com/support. Turn the UPS of. Make sure the The frequency is beyond frequency range is within 57 to 57 to 63 Hz 63 Hz.
CyberPower Systems for support. Flash 3 times Constant tone Charger Fault - Contact CyberPower Systems for support. every 5 seconds * The Power On LED will fash when UPS alarm is beeping. DEFINITIONS FOR ILLUMINATED LCD INDICATORS INPUT Voltage Meter:...
FAULT: outlets and turn the UPS on again.) The following number appears if there is a E01: Charger Fault (Contact CyberPower problem with the UPS. Press the POWER Systems for support) button to turn the UPS of.