Ice Maker - Hearthland HCFDR23C User Instructions

Ice maker operation & care
After the refrigerator is installed properly, the ice maker can
produce ice within 24 hours. It can completely fill an ice bin
in about three days.
When using the ice maker for the first time and in order
for the ice maker to work properly, it is necessary to clear
air from water filter tubing. Once ice maker begins making
ice, allow the bucket to fill completely, then discard the first
TWO FULL buckets of ice. It will take at least two days to
completely fill the bucket on regular ice making mode or 1½
days on fast ice mode.
The ice maker produces approximately four pounds of ice
every 24 hours depending on usage conditions.
NOTE
Your ice maker is turned on at the factory so it can work as
soon as you install your refrigerator. If you cannot connect
a water supply, lift the ice maker's wire signal arm to turn it
off. Otherwise, the ice maker's fill valve may make a loud
chattering noise when it attempts to operate without water.
Turning the ice maker on and off
Ice production is controlled by lifting/lowering the ice mak-
er's wire signal arm. To gain access to the ice maker, pull
the freezer drawer out. Lift the wire signal arm to turn the
ice maker OFF and lower the wire signal arm to turn it ON.
Figure 31
Ice maker tips
• If your refrigerator is not connected to a water supply or
the water supply is turned off, turn off the ice maker by
lifting wire signal arm.
• Ice cubes stored too long may develop an odd flavor.
Empty the ice bin as explained below.
AUTOMATIC ICE MAKER
On
Off
Wire
signal arm
16
• The following sounds are normal when the ice maker is
operating:
- Motor running
- Ice dropping into ice bin
- Water valve opening or closing
- Running water
Fast Ice Function
Your refrigerator is equipped with a Fast Ice Function, that
will, if activated at your user interface, allow an increase in
ice production. You do not need to deactivate it, if not need-
ed, your refrigerator will operate on normal conditions.
CAUTION
!
If the water supply to your refrigerator is softened, be sure
the softener is properly maintained. Chemicals from a water
softener can damage the ice maker.
Cleaning the ice maker
Clean the ice maker and ice bin at regular intervals, espe-
cially prior to vacation or moving.
1. Turn off the ice maker.
2. Remove the ice bin.
3. Empty and carefully clean the ice bin with mild deter-
gent. Do not use harsh or abrasive cleaners. Rinse with
clean water.
4. Allow the ice bin to dry completely before replacing in
the freezer.
5. Replace the ice bin. Turn the ice maker on.
Remove and empty the ice bin if:
• An extended power failure (one hour or longe)
causes ice cubes in the ice bin to melt and freeze
together.
Remove the ice bin and shake to loosen the cubes or clean
as explained above.
CAUTION
!
NEVER use an ice pick or similar sharp instrument to break
up the ice. This could damage the ice bin. To loosen stuck
ice, use warm water. Before replacing the ice bin, make
sure it is completely dry.