Advertisement
PRETECH
MOUNT BRACKET
Use fasteners as next, and see Fig 6.
No.
FASTENER
1
Bracket
2
Hex Head Screw
3
Flat Washer
4
Lock Nut
Nuts tightening torque
MIN. TORQUE
44.3 [lbf-in]
MAX.TORQUE
66.4 [lbf-in]
INSTALL ROTARY HELM
Place helm through the center hold and orientate the helm to give
the desire steering direction. There are multiple holes for mounting
the helm. Which ones you use will depend on your particular
installation location and cable routing.
If cable goes to the LEFT, hub cable openings should also go
left, etc.
Use fasteners as next, and see Fig 7.
No.
FASTENER
1
Rotary Helm
2
Star Washer
3
Hex Head Screw
Nuts tightening torque
MIN. TORQUE
44.3 [lbf-in]
MAX.TORQUE
66.4 [lbf-in]
MOUNT TRIM BEZEL
Place the trim bezel over the shaft and snap into place over the
mounting bracket. Align Tilt Cap with the Bracket carefully. Fig8
No.
PART NAME
1
TRIM BEZEL
INSTALL STEERING WHEEL
Fig9. Installing Steering Wheel
Turn steering wheel column until the keyway groove is top dead
center. (This will help to keep the keyway from falling out during
installation. Centering wheel adjustments will be made later while
attaching cable end to tiller.)
Place the woodruff key in the key slot on the shaft, then place
steering wheel on the shaft.
Use parts as next, and see Fig9.
(Shown steering wheel is just an example. It is not included.)
No.
FASTENER
1
Woodruff Key #9
2
Flat Washer
3
Lock Nut
MAN-0303 / Rev 20100601
DESCTIPTION
1EA
5/16-18 UNC, 3EA
5/16", 3EA
5/16-18 UNC, 3EA
(5.0 [N-m])
(7.5 [N-m])
DESCTIPTION
1EA
1/4", 3EA
1/4-28 UNF, L 0.75", 3EA
(5.0 [N-m])
(7.5 [N-m])
DESCTIPTION
1EA
DESCTIPTION
1EA
5/8", 1EA
5/8-18 UNF, 1EA
Fig 5. Clearance Requirement (Top view)
Fig 6. Mounting Bracket
Fig 7. Installing ZTS Rotary Helm
Fig 8. Mounting Cap
http://www.pretechco.com
Page 2of 4
Advertisement
