PRETECH 7400 Series Installation Instructions

PRETECH
INSTALLATION INSTRUCTIONS
7400XX ZTS Mega Pinnacle Rotary Steering System
7500XX ZTS Mega Rotary Steering System
7100XX 7000 Mega Pinnacle Rotary Steering System
7200XX 7000 Mega Rotary Steering System
Copyright 2010, PRETECH CO Inc. All Rights Reserved.
NOTICE : THIS INSTRUCTIONS CONTAIN IMPORTANT SAFETY INFORMATION AND MUST BE FORWARDED TO BOAT OWNER.
INTRO
These instructions show how to install the following products for Rotary
Steering Systems. See Fig 1.
P/N DESCTIPTION
700040 ZTS Rotary Helm (No Feedback)
700010 7000 Rotary Helm (Feedback)
Please check the following components are prepared.
COMPONENT DESCTIPTION
Installation Kit See Fig 2.
Steering Cable See Fig 3.
Steering Wheel See Fig 4. ( Not included )
And following tools are required. See Fig 4.
TOOL DESCTIPTION
1/4", 5/16"
Spanner
φ
Hand Drill
10mm[0.4"],
Hand Saw
General
1. Read this document thoroughly before installation.
2. Do not substitute parts without PRETECH's confirmation.
3. Every condition in this document must be fulfilled.
4. Do not disassemble any part of the product.
Incorrect installation or using of foreign parts may cause operation
failure which can result damage or injury to boat or person.
PRETECH will not be responsibility for any cases that are
inconformity to the conditions of this instruction.
CHECK CLEARANCE
To avoid interference & difficulty in assembling, check the
clearance requirements. And check the clearance for Steering
wheel's operation as Fig 5.
DRILL ON CONSOLE
After checking clearance, locate holes on dash.
Templates can be used to mark. See Drawing A.
If necessary, enlarge the center hole to accommodate the steering
helm assembly.
ONE HOLE MUST BE TOP CENTER.
MAN-0303 / Rev 20100601
φ
83mm[3.27"]
Safety Symbols, to alert
and indicate the level of risk
for the identified procedure.
Manufactured by PRETECH CO Inc.
192, Bangdo-Ri, Docheock-Myeon,
Gwangju-Si, Gyeongki-Do (Korea)
E-mail: sales@pretechco.com
Fig 1. ZTS / 7000 Rotary Helm (700040 or 700010)
1 BRACKET, 1EA
2 STAR WASHER 1/4", 3EA
3 HEX BOLT 1/4-28 UNF, 3EA
4 HEX BOLT 5/16-18 UNC, 3EA
5 FLAT WASHER 5/16", 3EA
Fig 2. Installation Kit
Fig 3. Steering Cable
Fig 4. Steering Wheel & Tools (Not included)
http://www.pretechco.com
Page 1of 4
6 NYLON NUT 5/16-18 UNC, 3EA
7 WOODRUFF KEY #9, 1EA
8 FLAT WASHER 5/8", 1EA
9 NYLON NUT 5/8-18 UNF, 1EA