Swing With Nano Sensor - SWING LOGIC SLX-Hybrid X3 User Manual

Swing with Nano sensor

Utilizing the Nano Sensor provides more accurate swing results.
Golf gloves are required when swinging using the nano sensor.
(Nano Sensor may be clipped to watch band or tape on wrist for putting analysis without a glove)
Mount the sensor as shown in the figure below and install it vertically in the correct position
to increase the accuracy.
If you use nano sensor, you can get more accurate swing results.
For accurate use, install it as shown in the figure below.
NANO Glove mount and Swing Guide
Insert the glove with top of clip facing up (wrist) as shown in the picture.
Insert the NANO sensor into the mount, turn it exactly 90 degrees clockwise
(USB should be facing towards thumb when properly installed.)
Limit waggle at setup to prevent Nano Sensor reset.
Swing within 3 seconds after address posture
Raise your wrist up with palm facing the ground and Nano Sensor horizontal,
to use +/- on the Nano Sensor for club selection
NOTE: Swing recognition may be difficult for extremely strong or weak grips.
The Nano Sensor can be adjust by turning the clip at an angle to improve setup recognition.
See website help documents for more information or reach out to support@swinglogic.us
SLX-HYBIRD X3 USER MANUAL
Left-handed people must wear
gloves on their right hand.
10