Advertisement
nd
The REVOV 2
LiFe R100 is a 2nd LiFe 16 cell, 51.2V, 100Ah, 5,1kWh, Battery Module with built-in BMS with CAN Bus
communications. Where inverter communications are required the unit's CAN bus communications provides State of Charge and other
information to supported inverters. In installations where no communications to the inverter are required the REVOV 2
as a lead-battery replacement. Automotive grade 2
assembled to meet the highest standards of SAFETY, RELIABILITY and LONGEVITY.
It is the perfect choice to provide backup power and integrate into Solar systems where daily cycling of the system is desired. It is common
to install just one battery to deal with blackouts but grow the system later. More batteries can be added easily onto a shared busbar for
those reducing their grid power usage in a phased approach. The REVOV 2
side for convenient wall and 19" rack mounting.
Model (external label)
R100
Revov Product Code:
2LIFE-R9-UBMS-R100-5.1
General Settings
Inverter Voltage (V) Settings
Maximum daily Charge current (A)
Recommended Charge current (A)
Max. Discharge Current Continuous) [A]
Recommended Recharge time (h)
Charging Temperature (
Output power capacity (W)
Total Energy (kWh)
Nominal voltage (V)
Capacity (Ah)
Scalability
The Revov R100 battery is designed for parallel operation only - do not arrange in series for increased voltage. Series
arrangement can result in damage to the Batteries and will void warranty!
Do not discharge battery below Low Voltage Disconnect voltage. Do not discharge battery at rates greater than
maximum continuous current.
REVOV R100 100Ah Battery Pack
2nd LiFe 51.2V
nd
LiFe cells and Revov 16 cell technology deliver superior performance under all loads.
Designed and Recommended Settings
Type
51.2V
LiFePO4 100Ah
Type
51.2V battery
Technical Specifications
Dependent on inverter type
Float Charge
Bulk / Boost /
Absorption Charge
Low Voltage
Disconnect
@25°C ambient
O
C)
LiFePO4
nd
LiFe R100 can be orientated with the "face" to the front, top or
Package Dimensions (mm)
L
H
530
220
Equipment Excl. Packaging (mm)
L
H
490
175
54.5 V
55.5V
49 V
50 A
30A
100 A 100A In-line fuse recommended
3 h Even 30A is sufficient
O
10 – 35
C Recommended
5120 W
5.12 kWh
51.2 V
100 Ah
Up to 16 Batteries in parallel
nd
LiFe R100 can act
W
Weight
500
50kg
W
Weight
480
48kg
Notes
Absorption 55 - 55.6 V
Load and temperature
dependent
Recommended
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for REVOV R100
Summary of Contents for REVOV R100
- Page 1 Scalability Up to 16 Batteries in parallel The Revov R100 battery is designed for parallel operation only - do not arrange in series for increased voltage. Series arrangement can result in damage to the Batteries and will void warranty! Do not discharge battery below Low Voltage Disconnect voltage. Do not discharge battery at rates greater than...
- Page 2 Parallel batteries with different open voltage as this may cause reverse currents, which could damage the batteries (done by qualified installers only). • The R100 battery is designed to sit in a cabinet, or mount on the wall. It is recommended to put the Batteries on the wall to avoid water damage or floods. •...
- Page 3 Consult the Inverter manufacturer’s manuals and/or access Revov technical support. Although Revov Lithium batteries can perform at very high rates and depths of discharge within a very wide temperature range, in order to achieve extended life cycles and to comply with the Warranty, this guideline document must be followed.
- Page 4 7. The battery should be charged completely once every 180 days when in storage. The battery pack comprises multiple systems that are designed to prevent hazards resulting from failures. However, due the nature of electrical systems, Revov cannot guarantee their absolute safety. Leaking Batteries If the battery pack leaks electrolyte, avoid contact with the leaking liquid or gas.
Need help?
Do you have a question about the R100 and is the answer not in the manual?
Questions and answers