Kurzweil K2661 Install Manual page 6

Installing Kurzweil K2661 ROM Options
Installing Object Files
Using the Boot Loader to Run Diagnostic Tests and Install Files
The Boot Loader is the special utility that enables you to install ROM option objects into the
K2661's flash ROM (unlike Disk mode, which loads objects into RAM). This is also where you'll
run the diagnostic test(s) to confirm the physical installation of the ROM options.
1. Turn your K2661 off, if it isn't off already.
2. Turn it on again, and watch the display carefully. When you see
3. Press the DIAGS soft button. The diagnostic test page will appear.
4. Use the cursor keys on the front panel of the K2661 to select either ROM 3 (for the SD
5. Press the Run soft button to run the selected diagnostic test. When test has completed, the
6. Press the Done soft button to return to the diagnostic test page. At this point, you can
7. Press the Install soft button. The Drive Selection page appears:
6
release the Exit button. This runs the Boot Loader. You'll see the main Boot Loader page:
Boot|Block|Main|||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
K2661|Boot|Block|v1.00|||||||||||||Valid
K2661|Hardware|Config|v1.00||||||||Valid
K2661|Engine|v1.00|||||||||||||||||Valid
User|Objects|||||||||||||||||||||||Valid
||||||| |||||| |||||| |||||||||||||||||||||
Install | |Run| | Reset | DIAGS ||||||||||||||||
Piano option) or ROM 4 (for the Vintage EPs option). If you have installed both ROM
options, you should run each test individually.
display will show whether or not the test has passed. (If the test fails, you should turn off
the K2661, disconnect the power cord, and check to see it the ROM option is seated
properly in its connector.)
either run the diagnostic test for the other ROM option (if installed), or press the Main soft
button to return to the main Boot Loader page.
||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||||||||||| |||||| ||||
|||||Device|to|install|from:|| SMedia||||
||||||||||||||||||||||||||||||||||||||||
|||||||SCSI|ID|of|this|unit:||N/A|||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||||||||Cancel||OK|||
, press and
Please|wait