Infinity PS212W Service Manual page 7

PS212W subwoofer
S C
YSTEM ONNECTIONS
Choose either Wireless or Wired Connection; then follow the appropriate instructions.
WIRELESS
Connecting the Subwoofer for Wireless Applications
DC18V
Step 1.
Connect a subwoofer cable from the subwoofer or LFE output of
your receiver to the Sub In › on the transmitter.
Step 2.
Plug the transmitter module into the wall outlet, and connect the
included power supply and power cord to the transmitter ¤ . Make
sure the Transmitter Antenna ⁄ is extended upward.
Step 3.
Set the ID Code on the transmitter ‹ and subwoofer ¢ to the
same position, as described on page 6. When connected properly,
the LED on the rear of the subwoofer will be orange.
Step 4.
Set the Low-Pass Selector § to the "Off" position.
NOTE: You may also connect a full-range output (such as a preamp
output or second-room output) from an A/V receiver or processor.
In that case, set the Low-Pass Selector § to the "On" position,
and set the Crossover Adjustment ¶ as described on page 6.
Some receivers have two subwoofer outputs. In that case, use
either connector.
ID
CODE
Sub In
1 2 3 4
WIRED
Connecting the Subwoofer for Wired Applications
If you have a Dolby ® Digital or DTS
a low-frequency effects (LFE) or subwoofer output:
If your receiver/processor does not contain a Dolby Digital
or DTS processor, but has subwoofer outputs:
NOTE: If your receiver/processor has only one sub out, you
may use either the L or R input.
6
® receiver/processor with
PS210W, PS212W (120V)