Advertisement
b)
The workshop crane must be examined immediately if it has been subject to an abnormal load or shock. It is recommended that
such an examination is made by an authorised service agent.
c)
The owner and/or operator must be aware that repair of this equipment will require specialised knowledge and facilities. It is
recommended that an annual examination of the workshop crane is made by an authorised service agent.
d)
Unauthorised parts may be dangerous and will invalidate the warranty.
7.8.
DEFINITION OF 'INSPECTION' AND 'EXAMINATION' BELOW.
INSPECTION:
Inspect the crane for defects and check the operation of controls, limiting and indicating devices without loading the crane. This check
does not normally require any part of the crane to be dismantled other than removal or opening of covers or housings.
EXAMINATION:
Verification that the crane can safely continue in service including a functional test of all safety devices i.e. limiting, indicating
equipment, brakes, clutches, safety valves etc. to verify that they operate within the required tolerances. An examination is
more thorough than an inspection.
7.9.
DAMAGED CRANES.
Any crane which appears to be damaged, badly worn, or operates abnormally MUST BE REMOVED FROM SERVICE! It is
recommended that necessary repairs be made by an authorised service agent.
8. TROUBLESHOOTING
Fault
Cause
Can't lift load
1. Overload
2. Release valve not completely closed
3. Air in hydraulic system
Cant lift to full height
1. Oil low
2. Air in hydraulic system
Oil leaking
1. Seals failed
2. Loose screw parts
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component
parts without prior notice. Please note that other versions of this product are available. If you require documentation for alternative
versions, please email or call our technical team on technical@sealey.co.uk or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
Remedy
1. Remove partial overload
2. Check the release valve
3. Purge air
1. Add oil
2. Purge air
1. Replace seals
2. Tighten the screw parts
01284 703534
sales@sealey.co.uk
Original Language Version
REGISTER YOUR
PURCHASE HERE
www.sealey.co.uk
SC10LR.V3 Issue 1 31/08/22
Advertisement
