Advertisement
1.
While pressing and holding
Release
[RESET] button only and make sure that all marks on the remote controller display are indicated
then release the
2.
Press the
(MODE) selector button so that the display indicates
3.
Press the
( ON/OFF ) button and FAN operation will be started.
4.
Set the FAN SPEED with the
setting in order to choose the desired operation mode that is required for shift value setting
temperature modification.
−
To change the shift value for COOLING mode operation, select either
−
To change the shift value for HEATING mode operation, select either
5.
Press the (TEMP
NOTE
:
1.
The displayed shift value,
disappear after 10 seconds.
2.
The changed shift value will remain unchanged after turned off the power.
3.
If "O" is displayed on the remote controller display, it indicates the shift value is now at the initial setting
(ON/OFF) button and
(ON/OFF) button and
(FAN SPEED) button according to the following FAN speed
o r
) button to change the shift value. (The shift value changed with device producing beep sound.)
(HEAT) and
(CO OL) symbol on the remote controller display will
- 119 -
button, press
button. Remote controller now enters "Shift Value Change Mode".
(FAN) mode.
(HIGH) or
(LOW) or
[RESET] button on the same.
(MED) FAN SPEED.
(SILENT) FAN SPEED.
.
Advertisement
