ON Semiconductor AND9670/D Quick Start Manual page 4

•
Code structure of the example appears on left window under Project Explorer, named AS3993_RFID. It usually
happens there is a small red cross visible close to the name of the project. This is due to indexing that has to be
rebuilt. In order to remove the red cross, right click on the AS3993_RFID, go to Index and left click on Rebuild. It
disappears after few seconds.
•
Go to Device Manager and identify the USB Port number. In this example COM3 was recognized and the value in
file "config.cfg" was modified with the COM3. Save the modified file
•
Left click on the project AS3993_RFID to highlight the selected project and press the ON icon in the menu bar as
depicted in the Figure 5 below. A console window opens with the prompt to reset the board and starts the time
count−down immediately
AND9670/D
Figure 3. IDE
Figure 4. USB Port Configuration
www.onsemi.com
4