Table of Contents
Advertisement
1.
Press the MENU key to open the OSD.
2.
Toggle the joystick to the up or down to select Gaming from the OSD.Then toggle to
the right to navigate to the element you wish to adjust and press the joystick to enter it.
3.
Toggle to the left or right to adjust the sliding scales.
4.
Over Drive: Select Off, Normal, or Extreme.
5.
AdaptiveSync: To control support AdaptiveSync or not, default is On.
---------------------------------------------------------------------------------------------------------
Note:
1. If AdaptiveSync is "ON", then the Over Drive selection is set to "Normal"
automatically.
2. If AdaptiveSync is "OFF", then the user can set Over Drive to either one of
the three settings including: (a) Extreme (b) Normal (c) Off.
6.
Refresh rate num: Display the panel's current refresh rate on the screen.
-----------------------------------------------------------------------------------------------------------
Note: If AdaptiveSync set "On" you can see the V Frequency to changes in the
OSD.
7.
VRB: To choose whether to support dynamic picture more clean control, default is Off.
---------------------------------------------------------------------------------------------------------
Note:
1. HDR setting: "Auto" is not support VRB.
2. VRB set "On", when to turn on AdaptiveSync, will auto set VRB is "Off".
3. VRB set "On", when to adjustment (Brightness, Blue Light, ACM), will auto
set VRB is "Off".
4. VRB function does not affect the (Logo, Aim Point, Message and Input Icon)
brightness.
5. VRB setting "On", when detection of Input Timing <75Hz, will auto off the
VRB and gray out to disable.
6. VRB = (Normal or Extreme), because the IC control dynamic picture is
cleaner, so the overall Brightness will be dark, "Extreme" will be darker than
"Normal".
Ultra-Low Latency: Set to On to speed up the processing time of the display switching
8.
process.
---------------------------------------------------------------------------------------------------------
Note:
1. AdaptiveSync is On, the Ultra-Low Latency automatic set to On and gray
out unavailable.
2. Ultra-low latency is not supported at resolutions below 800x600.
9.
Aim point: Show an Aim point on the screen for shooting games.
-----------------------------------------------------------------------------------------------------------
Note: In PBP mode the Aim point not displayed.
Advertisement
Table of Contents
