Table of Contents
Advertisement
7. After installing the System Control Box of both displays, the installation wall
should look like:
8. Connect one end of an HDMI cable to the HDMI OUT port of Display 2. Then,
connect the other end of the cable to the HDMI IN port of Display 1.
HDMI IN
NOTE: Route the HDMI cable as shown below:
9. Install the System Control Box Covers with the KM3x6mm screws from left to right
(i.e., Display 1 left cover, Display 1 middle cover, Display 1 right cover, Display 2
left cover, etc.).
NOTE: Refer to page 26 for more information.
Display 1
Display 2
46
HDMI OUT
Advertisement
Table of Contents
