Cafe C7CEBAS3RD3 Owner's Manual page 14

Using your Espresso Machine
Steam and Hot Water
CAUTION
To avoid possible burns to body parts and/or other injury from hot steam,
do not touch liquids or steam wand during or after steaming. Do not remove pitcher until
steaming is complete. Hold milk pitcher by the handle.
NOTE: Steam function is only available with model C7CEBBS2RS3, C7CEBBS3RD3, & C7CEBBS4RW.
NOTE: Make sure you have a coffee cup or container placed under the steam wand before using
either function.
Hot water will dispense when the Hot Water button is pressed. To stop the water dispensing press
Hot Water again.
To use the Steam function, press the Steam button to initiate the process. The Steam Wand Light will
start flashing. While steam is preheating a small amount of water or steam may purge into drip tray.
Point steam wand towards drip tray. Do not introduce milk until steam is preheated. To stop the steam
dispensing press Steam again.
NOTE: No coffee beans are used for this function.
NOTE: Hot Water comes out of steam wand if present. Hot water comes out of spout for models
without the steam wand.
Custom Dispense Amount
Steam wand
Press and hold any of the function buttons for 3 seconds until 2 beeps sound.
The machine will begin to dispense for the selected function.
To choose a new dispense volume, press the function button again. The machine will stop. 2 more
beeps will sound and the new dispense volume will be set. The machine will return to idle state.
NOTE: If no custom dispense amount is set, the maximum volume will be the custom dispense
amount.
NOTE: Adjustable volume ranges are different for each function. For detailed volume
options, refer to the SmartHQ app.
NOTE: Changing the volume presets may alter the flavor and strength of the coffee.
NOTE: The Americano function has a different volume adjustment style. Hold for 3 seconds to
start adjusting, then press once for coffee and again for water volume change. For other functions
the selection happens only once.
NOTE: Pump may airlock (pull air in) when machine runs out of water. This condition may occur when
the outside of the water tank is wet. Airlock is indicated by the Add Water alert paired with flashing
Hot Water button. To prime the pump, refill tank, dry off outside of tank, and run Hot Water function
until air is cleared out of the system.
14