Performance; Names Of Each Parts - Hitachi UST-547 Instruction Manual

MN1-5053 Rev. 15

2-3. Performance

For measurement tolerances, operating tolerances and other data, refer to the instruction manual for the
ultrasound diagnostic instrument.

2-4. Names of each parts

Probe tip
This area is held during operation.
Front Mark
The protrusion corresponds to the
front mark (direction mark) on the
image display.
Caution
Do not pull, bend, twist, or apply excessive force to the cable.
The conductors may break and the cable may become unusable.
Do not subject the ultrasonic irradiation area to hard impact.
The impact may cause damage to the transducer, and that results in noise or no echo in the image.
In most cases, the ultrasonic irradiation area itself is not damaged because the part is made of elastic
material.
Ultrasonic irradiation area
This incorporates an electronic linear
transducer.
Cable
This cable propagates the ultrasonic signals
that are sent and received.
Connector
This is the part that connects the ultrasound
diagnostic instrument and probe. Follow the
instructions in section 4-2.
-14-