Table of Contents
Advertisement
Section 01 MAINTENANCE
Subsection 03 (FLUSHING AND LUBRICATION)
Start the engine then immediately open the water
tap.
;
WARNING
Do not touch any electrical parts or jet pump
area when engine is running.
-
CAUTION
Never flush a hot engine. Always start the
engine before opening the water tap. Open
water tap immediately after engine is start-
ed to prevent overheating.
Run the engine about 3 minutes at a fast idle
around 3500 RPM.
Spray BOMBARDIER LUBE lubricant through air
intake silencer keeping engine at fast idle.
1
F01F25A
1. Air intake silencer
2. Pull plug
3. Spray BOMBARDIER LUBE here
NOTE: Lubrication of engine should be done at
least for 1 minute.
Close the water tap then stop the engine.
-
CAUTION
Always close the water tap before stopping
the engine.
Disconnect the garden hose.
-
CAUTION
Remove quick connect adapter after flush-
ing operation (if used).
01-03-2
2
3
Wipe up any residual water from the engine.
Remove spark plug cables and connect them on
the grounding device near the tuned pipe.
;
WARNING
Always use spark plug cable grounding de-
vice when removing spark plugs.
F07H0AA
1. Grounding device
Remove both spark plugs and spray BOMBAR-
DIER LUBE lubricant into each cylinder.
NOTE: For the storage period, use Bombardier
storage oil (P/N 413 711 600).
Fully apply the throttle lever then depress the
start/stop button to crank the engine a few turns
to distribute the oil onto cylinder wall.
Apply anti-seize lubricant on spark plug threads
then reinstall them.
Reinstall plug on air intake silencer cover.
NOTE: Engine fogging should be done whenever
the watercraft is to be stored for a few days or a
long period.
-
CAUTION
Never leave rags or tools in the engine com-
partment or in the bilge.
1
Advertisement
Chapters
Table of Contents
