BOMBARDIER SEA-DOO GTX RFI 5666 1998 Manual page 38

Section 05 ELECTRICAL SYSTEM
Subsection 03 (CHARGING SYSTEM)
STATIC TEST: INSULATION
1. Disconnect the magneto wiring harness con-
nector.
2. Install the 4-pin magneto harness adapter (P/N
295 000 131).
3. Insert multimeter positive (+) probe to the YELLOW/
BLACK wire of the 4-pin magneto harness
adapter.
4. Ground the multimeter negative (-) probe to the
engine or the stator iron core and note the read-
ing.
5. Repeat test with the other BLACK and RED/
BLACK wires of the 4-pin magneto harness
adapter.
NOTE: There should be no continuity (infinity) be-
tween the stator insulated coils and ground. If
there is a reading, the stator coils and/or the wir-
ing from the coils is grounded and needs to be
replaced or repaired.
05-03-2
DYNAMIC TEST
1. Disconnect the magneto wiring harness con-
nector.
2. Install the 4-pin magneto harness adapter (P/N
295 000 131).
3. Connect test probes of the multimeter to the
YELLOW/BLACK and RED/BLACK wires of the
4-pin magneto harness adapter.
4. Set multimeter to Vac scale.
5. Start and rev engine to 3500 RPM. The ob-
tained value should be between 45 and 70 Vac.
6. Repeat test with the BLACK wire and either the
RED/BLACK or YELLOW/BLACK wires of the
4-pin magneto harness adapter.
7. If the stator is out of specification, replace it.