Advertisement
! C
G
ONFIGURATION
In the tables, the following items appear:
"<Select>"
o
"<User Defined>", etc. Type in the desired name for the item.
o
C
IR O
ONFIGURING
UTPUTS
This table provides settings used in the Configurator to setup the IR outputs on the XANTECH XLIP.
Configure the IR outputs on the Input/Output tab in Configurator.
Devices
Communication Devices
IR Senders
IR Receiver
RS-232 (XLIP232 Only)
Notes:
1. By default, set the Xantech XLIP to 192.168.1.33. If you have more than one Xantech XLIP, set the second to 192.168.1.34 and so on.
C
RS-232 P
ONFIGURING
This table provides settings used in Configurator to setup the serial port(s) on the XANTECH XLIP.
Configure the serial ports on the tab of the system that the serial port will connect to.
Important: Configure the XLIP IR outputs as shown above before configuring any XLIP Serial ports.
Devices
Communication Devices
Name
Communication Type
Hardware Type
XLIP Device
Ip Address
Port
Note: By default, set the XLIP to 192.168.0.41. If you have more than one XLIP, set the second to 192.168.0.42 and so on.
IMPORTANT: The XLIP232 serial port's baud rate must be configured on the XLIP device and not in
the g! configuration software..
D
ETAILS
Select the desired item from the list (or drop-down) in Configurator.
Variable Name
<User Defined> (Default: Xantech XLIP)
Device Name
Communication Type
Standard Connecton
Hardware Type
(IP to Serial) Xantech XLIP232
Device
<Discovered>
<User Defined> (Default: 192.168.1.33) (See Note 1)
IP Address
Port
65432
Name
<User Defined>
Device Type
Xantech XLIP
COM Device
<Select> (Default: Xantech XLIP)
Output Number
<Select>
Name
<User Defined>
Device Type
Xantech XLIP
COM Device
<Select> (Default: Xantech XLIP)
Name
<User Defined>
Communication Type
Standard Connection
Hardware Type
(IP to Serial) Xantech XLIP232
XLIP Device
<discovered>
Ip Address
<user defined>
Port
<User Defined>
ORTS
Variable Name
<User Defined>
Standard Connection
(IP to Serial) Xantech XLIP232
<discovered>
<user defined>
<User Defined>
Setting
Setting
10 of 11
Comments
For eg: Comcast (IR2)
1 or 2 for IR output #1 or #2
For eg: Comcast (IR2)
Comments
Advertisement
