Flash Furniture Savannah JJ-C14705-BK-GG Assembly Instructions Manual

All-weather rocking adirondack chair

Advertisement

Quick Links

ASSEMBLY INSTRUCTIONS

Before You Begin:

Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the
components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching
during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to product or components may
result.
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware (where
included) to help prevent the unit from tipping and causing accidental injury, instability, death or damage. The
tipping restraint is intended only as a safety measure, it is not a substitute for proper adult supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall
Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.
Customer Service Email:
JJ-C14705-BK-GG
Rocking Adirondack Chair
CustomerExperience@belnick.com
I
JJ-C14705-GY-GG
I
JJ-C14705-SFM-GG
Thanleyoufaryourpurchase!
All-Weather
I
Phone: 866-552-2810
I
JJ-C14705-WH-GG

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Savannah JJ-C14705-BK-GG and is the answer not in the manual?

Questions and answers

Summary of Contents for Flash Furniture Savannah JJ-C14705-BK-GG

  • Page 1 Thanleyoufaryourpurchase! All-Weather Rocking Adirondack Chair ASSEMBLY INSTRUCTIONS Before You Begin: Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching during assembly.
  • Page 5 STEP 3: Attach the Rockers (Part J) and Front Crossbeam (Part G) to the Front Legs (Part F) using (2) M6*50 Bolts (CC) then hand tighten. Rocker Rocker NOTE: Bolt goes from the outside through the Rocker and Front Leg then into Crossbeam.

This manual is also suitable for:

Savannah jj-c14705-gy-ggSavannah jj-c14705-sfm-ggSavannah jj-c14705-wh-gg

Table of Contents