Fault
The door cannot
be opened.
The water is not drain-
ing.
Cause and troubleshooting
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 50
▶
Water level is too high.
Start the Drain programme.
▶
Power failure.
Open the door using the emergency release.
▶
→ "Emergency release", Page 76
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 61
▶
is activated.
Rinse Hold
Continue the programme by selecting Spin or
▶
Drain and pressing Έναρξη/Προσθήκη
.
ρούχων
→ "Resuming the programme when the programme
status is Rinse Hold", Page 50
The water outlet hose is connected too high.
Install the water outlet hose at a maximum height of
▶
1 metre.
Pump cover is not correctly assembled.
Correctly assemble the pump cover.
▶
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
If intelligent dosing is activated, reduce the basic
▶
dosage → Page 53.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
Unapproved extension installed on the water drain
hose.
Remove any unapproved extensions from the water
▶
hose. Connecting the appliance
Troubleshooting en
69