Table of Contents
Advertisement
en operation
12.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
Requirements
¡ A programme is set.
→ "Setting a programme", Page 29
¡ The programme settings have
been adjusted.
→ "Adjusting the programme set-
tings", Page 29
Press and hold
▶
seconds.
Press
to call up the saved pro-
gramme.
Note: To overwrite the saved pro-
gramme, repeat the steps above.
12.5 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 26
Requirements
¡ The laundry is prepared and sor-
ted.
→ "Laundry", Page 29
¡ The drum is empty.
Open the door.
1.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
12.6 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 29
Press
.
▶
a The display shows the programme
duration or the "Ready in" time.
a After the programme has ended,
the display shows: "End" .
30
for approx. 3
Note: If "Hot" appears, the appliance
cools the laundry.
When "Hot" goes out, the laundry
has cooled down.
12.7 Adding laundry
After the programme starts, you can
remove or add laundry at any time.
Requirement: A programme has
started.
→ "Starting the programme",
Page 30
Press
.
1.
The cooling process starts auto-
matically after approximately 30
seconds and cools down the laun-
dry while the drum is rotating. If
you want to avoid or cancel the
cooling process, open the door.
→ "Display", Page 21
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
.
5.
12.8 Cancelling the pro-
gramme
Press
.
1.
Open the appliance door.
2.
Remove the laundry.
3.
→ "Unloading the laundry",
Page 30
12.9 Unloading the laundry
Open the door.
1.
Remove the laundry from the
2.
drum.
12.10 Switching off the appli-
ance
Press
.
▶
Advertisement
Table of Contents
