Advertisement
RB10GM14B
Section 1: Disassembly (cont.)
Part Four: A Pillar Removal
Step 1
Remove the inserts covering the
bolts on the passenger A pillar
handle.
Part Five: Lower Steering Column Cover Removal (Optional)
If the vehicle is equipped with IO3, IO4, IO5 or IO6 radio AND steering wheel controls, follow the steps
below to remove the lower steering column cover. For IOB vehicles or no steering wheel controls, proceed
to Section Two on next page.
Step 1
Remove the two Torx T15 screws
from the bottom edge of knee
panel below the steering column.
Pull outward to remove the panel
and lay carefully on the floor board.
®
Pacific Accessory Corporation
Step 2
Remove the two 10mm bolts.
Step 2
Remove the plastic handle from
the steering wheel tilt lever by
pulling outward, towards the
driver's door on the handle. A trim
tool may also be used if unable to
remove by hand.
© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
Stinger HEIGH10 Radio Replacement Kit
®
for select 2014-2019 Silverado/Sierra Truck
Step 3
Pull the trim panel to release the
retaining clips and remove.
Step 3
Pull downward on the lower
cover on both sides to release
the locking tabs and remove the
lower cover.
Rev: V1
Date: 030121
Page 6
Advertisement
