Smeg DWAU315XT Instruction Manual page 17

User instructions
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph "
S
TARTING THE PROGRAM
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
OPTION SELECTION
Options are selected by pressing the relative button by the symbol of the
option required; the light comes on to confirm that the option has been
activated.
•
It is not possible to select any options when the soak
program is being used.
•
All options except "Flexi Tabs" are disabled at the end of the
wash cycle. To disable the "Flexi Tabs" option, press the
relative button (the light goes out).
•
All options, including "Flexi Tabs" are disabled when a
program is CANCELLED after it has begun.
ENERSAVE
This option can be selected with the wash programme of choice to
further reduce energy consumption. Drying is aided by a special
device that automatically releases the door, which opens slowly and
smoothly by a few centimetres. This ensures perfect drying and greater
control of rinsing temperatures, which can be kept at lower levels for
significant energy saving. Once the door has opened, the end of the
wash cycle is indicated by a short beep.
Enersave is activated automatically every time a wash cycle is
selected (except for programs that do not include the final drying phase;
see programs table) and can be disabled before the program is started.
Flexi Tabs, once selected, remains enabled until intentionally disabled.
When the function is activated, opening of the door must not be
impeded in any way; do not leave anything in the space in front of the
door necessary to allow it to open.
Do not re-close the door during automatic opening as this would
damage the mechanism. Wait for the pushers to retract before re-closing
the door.
". The program will resume from the
15