IOTA DLS-UI-27-40 Manual

IOTA DLS-UI-27-40 Manual

Advertisement

Thank you for purchasing IOTA's DLS Series Power Converter/Battery Charger. When utilized properly, your DLS Power
Converter/Battery Charger will provide years of dependable service. This Owner's Manual contains important safety and
operating instructions. READ ALL INSTRUCTIONS AND SAFETY PRECAUTIONS CAREFULLY BEFORE INSTALLING
AND OPERATING THE UNIT.
WARNING
Risk of SERIOUS INJURY OR DEATH
This unit is an electrical device. When working with this, or any
electrical device, there exists the potential for
ELECTRICAL SHOCK, EXPLOSION and FIRE hazards.
Before using this equipment, READ AND UNDERSTAND the
instructions, warnings, and safety precautions in this Owner's
Manual. Failure to read and understand these instructions could
result in SERIOUS INJURY or DEATH.
SAVE THESE INSTRUCTIONS
CAUTION
When working with the DLS unit, always observe the fol-
lowing guidelines:
• The DLS is designed for indoor use. Do not use outdoors.
• DO NOT expose the DLS unit to rain, snow, or other
inclement weather.
• Do not mount the DLS in a zero clearance compartment or
in compartments with flammable items such as gasoline
or batteries.
• Do not mount the DLS in an area with the potential of
dust, debris, or other foreign materials entering the vents
of the DLS.
• Use of an attachment or device with the DLS not recom-
mended by IOTA Engineering will void the warranty and
may result in a risk of fire, electrical shock, or injury to
persons.
• To reduce the risk of damage to the electric plug and cord,
always pull by the plug and not the cord when disconnect-
ing the unit.
• DO NOT operate the DLS with a damaged cord or plug.
• DO NOT operate the DLS if it has been dropped, received
a sharp blow, or has been otherwise damaged in any way.
Take the DLS unit to a qualified service location.
• DO NOT disassemble the DLS unit. Take the DLS to
a qualified service location when service or repair is
required.
• To reduce the risk of electric shock, DISCONNECT the
DLS charger from ALL power sources before attempt-
ing any maintenance or cleaning. Turning off any electri-
cal supply or load to the unit is not sufficient and will not
reduce this risk.
DLS
SERIES
DLS-UI-27-40 CONVERTER/CHARGER
OWNER'S MANUAL
DANGER
ELECTRICAL SHOCK HAZARD
THIS CHARGER IS AN ELECTRICAL
DEVICE THAT CAN SHOCK AND CAUSE
SERIOUS INJURY.
DO NOT CUT POWER CORDS.
DO NOT SUBMERGE IN WATER OR GET
THE CHARGER WET.
EXPLOSION HAZARD
UNSUPERVISED, INCOMPATIBLE, OR
DAMAGED BATTERIES CAN EXPLODE IF
USED WITH A CHARGER.
DO NOT ATTEMPT TO CHARGE DAMAGED
OR FROZEN BATTERIES.
USE THE CHARGER ONLY WITH BATTER-
IES OF RECOMMENDED VOLTAGE.
OPERATE THE CHARGER IN
WELL-VENTILATED AREAS ONLY.
WARNING
FIRE HAZARD
A CHARGER IS AN ELECTRICAL DEVICE
THAT EMITS HEAT AND CAN BURN.
DO NOT COVER THE CHARGER.
KEEP THE CHARGER AWAY FROM
COMBUSTIBLE MATERIALS.
DO NOT SMOKE OR USE ANY
OTHER SOURCE OF ELECTRICAL
SPARK OR FIRE WHEN OPERATING
THE CHARGER.
RISK OF EXPLOSIVE GASES
WORKING IN THE VICINITY OF LEAD-
ACID BATTERIES IS DANGEROUS.
BATTERIES GENERATE EXPLOSIVE
GASES DURING NORMAL BATTERY
OPERATION. FOR THIS REASON, IT IS
OF UTMOST IMPORTANCE THAT YOU
FOLLOW THE INSTRUCTIONS WHEN
USING THE BATTERY CHARGER.
To reduce the risk of battery explosion, follow
these instructions and those published by the
battery manufacturer and review all Cautions
and Warnings associated with these products.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DLS-UI-27-40 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for IOTA DLS-UI-27-40

  • Page 1 DLS-UI-27-40 CONVERTER/CHARGER OWNER’S MANUAL Thank you for purchasing IOTA’s DLS Series Power Converter/Battery Charger. When utilized properly, your DLS Power Converter/Battery Charger will provide years of dependable service. This Owner’s Manual contains important safety and operating instructions. READ ALL INSTRUCTIONS AND SAFETY PRECAUTIONS CAREFULLY BEFORE INSTALLING AND OPERATING THE UNIT.
  • Page 2: Product Description

    IOTA unit to the load side. Connect “Chassis Bonding Lug” fan-starting noise. on the IOTA unit to vehicle chassis or other grounding source.
  • Page 3: Charge Control

    The green LED on the fan end of the unit will indicate which charging is complete. NOTE: If the unit is equipped with charging phase the IOTA unit is currently in. When the unit an internal IQ4 smart charger, two-step charging is not is first activated, the LED will flash as it reads the number needed and the Dual Voltage Jack is disabled.
  • Page 4: Technical Specifications Chart

    13″ x 8.3″ x 3.4″ Weight 9 lbs Input Cord IEC C-14 Primary to Chassis/Primary to Secondary/Secondary to Chassis Distributed By: IOTA ENGINEERING PO BOX 11846 TUCSON, AZ 85734 TEL: 1-800-866-IOTA (4682) FAX: (520) 741-2837 WEB: www.iotaengineering.com 68357-C27 REV 082613...
  • Page 5 CONVERTISSEUR/CHARGEUR DE BATTERIE GUIDE DE PROPRIÉTAIRE Merci pour votre achat du Convertisseur/Chargeur de batterie de la série d’IOTA Engineering. Lorsqu’il est utilisé correctement, ce Con- vertisseur/Chargeur de Batterie DLS pourra fonctionner pendant plusieurs années. Ce Manuel du propriétaire contient d’importantes instructions de sécurité...

This manual is also suitable for:

Dls series

Table of Contents